Nice tip for that removal tool... Cheers....👍

Cool video 👍👍👍👍

Great videos mate! I’ve learnt a lot. I’m having a problem with the same boiler. It’s fault was e156 under voltage. Check all voltage everything was fine. However it would not reset. So, I had a spare pcb so changed it and it all fired up fine/ 1 day later I get E168 that fault code ses needs a reset, the boiler now does reset but won’t fire up on heating. And hot water brings up the fault code again. What would be looking for next? Would the flow turbine and actuator give these fault codes? Thanks

Hi. Great video. Thanks! I have this boiler but I don’t think I have the water turbine. There is a sensor clipped on to the water flow pipe. But I have an issue that there isn’t hot water when the go is on. Only when the bath is on. And this just started. Any idea what it would be?

Hi Did you ever make a video on taking 'the right hand block' out? (water pump?) My flow sensor is not coming out for love nor money, and as you have shown - access to it is not great. I've bought the tool but all it's doing now is slipping on the brass top of flow sensor. Thanks

What is it when you turn a tap on upstairs .then turn the tap off Then the boiler still thinks the taps open yet when you turn the downsiars kitchen tap on and off the dhw light on the boiler goes off .

so what the reason for this specific tool? will a standard 18mm not work?

Or you could use an 18mm socket.

18mm socket does it too.

Those things don't come out after 8 years.