No video
Making a Model train sensor for motor on trigger to drive a Puff & Brake fan motor for Puff smoke.
Рет қаралды 262
Күн бұрын
@user-mg6ix6sl9g Ай бұрын
Better small board. Good job !
@DennisMurphey Ай бұрын
Well i choose the wrong type perfboard Next one will work perfectly I need to keep all the parts and jumpers on one side so it as thin as possible, You will see, D
@kapioskapiopoylos7338 Ай бұрын
have a look on smd bridge rectifiers, md8/md6 are quite nice, they would make your life so much easier.
@DennisMurphey Ай бұрын
@@kapioskapiopoylos7338 Are you kidding me, 600V peak 30A peak 47 Cents, 4 pads ????? eu.mouser.com/ProductDetail/onsemi-Fairchild/MDB6S?qs=M80ie1ekFqMJxSM%2FpN%2F%2F4w%3D%3D
@kapioskapiopoylos7338 Ай бұрын
@@DennisMurphey Carefull with the peak current ratings, these are for capacitive loads, the datasheets explain in great detail how long they can do that. In general they are robust components. As for the cost, the solder you used is probably, more. Glad it was helpful. Don't worry about the current the 1n400x series is equal or less capable to the MD bridges.
Frankentrain Laboratories
Рет қаралды 120
Frankentrain Laboratories
Рет қаралды 1,8 М.
Flyer Atlantic 300 SMOKES! 4 wire Harness build & installed. Tender is done. Engine needs headlight.
Frankentrain Laboratories
Рет қаралды 143