Maybe take the spacers out brother. It’s all about the offset. I know it looks bad ass with a little stance though. Back in the day on my grand Cherokee I had to cut the punch weld back which gave me enough room to run oversized tires. I was thinking of running the same setup as you. I want 37’s with the least height needed lol. Especially with a 18 inch rim. I like that look.

Great info brother. I’m debating if I want to go with a 6 or 8 inch lift. Since you have to cut mounts anyway for the lift. I wish I can run 18’s. I like the look of more tire less rim. I’m sure yours looks like a beast

Going to do the same this week. Still want a place to bolt on a set of mud flaps. So instead of cutting going to try and just hammer it in so I can still screw into the clip.

@rokatopo1441 let me know how you make out brother.

Glad to help brother let me know how you make out.

You got it brother.

The only way to push out the wheels is with spacers or another rim with negative offset. If you go the spacer route check out my how to install spacers the correct way video. Make sure you get a reputable company and you’ll be good to go. Let me know how you make out brother.

Also the bigger the spacer the more it rub on the little mudguard

You’d need to lift it and add a spacer. I got a set of wheels with a -19 offset with stock size tires and I run on the plastic inner fender.

In my honest opinion they are horrible. With a light dusting of snow I was all over the place. I bought a set of wild peaks at3w and they are great in rain, they have the three peak snow and ice rating. Also I highly recommended duratracs they were great on my jeep.

It only rubbed because of the spacers. And it only rubbed when it was in reverse on the plastic mud flap shield. Other than that it doesn’t rub anymore. I took it off road and have full flex on bumps and when stuffing the tire up.

I also have a 2 inch level on it as well. I’m pretty sure I would of fit a 34x12 wide if not 35x12. There is plenty of room. Hope that helps Victoria.

Just installed 37" with a zone 6 inch lift today and mine seems to be rubbing in the same place forward or reverse.. I took those little flaps off and the Tab where the clip goes into is clearly the source of contact. Was that tab about an inch? I'm hoping that's all I'll need to clear these.. 35" were no issue.

Man bro let me know if you get a 37 to fit with no issues. What offset you running on the wheel? The tan was about 1 inch bro. You also have to account for the tire going up and down as in off road. It might hit with up travel. Let me know brother how it turns out for you though.

@@MrV2u .. 0 offset.. I like the clean look without sticking out too far.. looks like plenty of up travel but the damn tab appears to be the issue.. The tire place said they've been able to do wheel alignments and adjust either camber or caster to get the clearance in some circumstances. Wasn't sure which they said cause I kept thinking back to the pinch weld I cut out with my 2012 tacoma. I'll keep you posted my friend. Thanks for the video and help!