Yes, soon!

Hi Jennifer! There is a navigation puck that needs to be ordered and installed by a dealer (if you don't already have it), then the chip needed depends on where you are in the country, and you'll need a Navionics SD card. If you have the 2020 or newer system, they did away with mapping assuming most people just use their phone maps!

Most manufacturers have different recommendations for the break-in period. I would ask your service department and/or refer to your engine manual for specifics on your motor.

You can either fully reset it to factory settings, which would delete any presets you have created, reset the start code, turn off any accessory buttons so you'd need to turn them back on, etc., or you can tell me which preset you deleted and I can tell you how to rebuild it!

@@ChantelBoats Thanks for your rapid response :) We don't have any presets yet so I gather the simplest is to reset, I hope I can the reset function easily in the menu....your help is much appreciated !

Hi Brett! Normally, as a safety feature, the boat needs to be moving faster than 1mph for the Wedge to come all the way into stow. In the showroom, I used a backdoor in the settings (on the small screen) to slowly bring it all the way up. Page 72 of the 2019 Owner's Manual shows instructions.

Chantel Herbert thanks for the reply. I have a 2018 VLX. Can this be done on the 18’s. I have no access to a 2019 manual. Thanks. I put it down in the driveway when I first got the boat and had to get to the lake to put it up.

@@brettu2587 Oh dang!! What I did is in a new screen for 2019. I think a lot of people have done exactly what you did! It doesn't hurt anything to tow it with the Wedge down in the case that it happens - most boat shows we end up driving boats back with all the Wedges down! There are a couple ways to get it back up without going to the water - if you have the boat in Zero Off speed control mode, you can hook up to a truck and tow the boat at 1-10mph with someone in it putting the Wedge up. If it's in Paddle Wheel mode, you could have someone climb under the boat and spin that paddle wheel (or use an air compressor to blow it so it spins!) so it thinks you are moving and someone in the boat putting the Wedge up. Sorry, I know neither is ideal, but could work if you need to have it up!

Chantel Herbert thanks for the tip.

They used to have an app that I'm pretty sure let you add a custom photo, but the app isn't available anymore. As far as I know, there isn't a way to upload one directly into the system.

@@ChantelBoats Oh okay. I was just confused on why it has more open slots for pictures that say "user image" . Thank you!

Same screen!

It does rotate, but it isn't necessary to rotate it for travel, more just to make adjustments depending on who is driving.

TXi only. They have different screens.

@@ChantelBoatsthank you! What about the letter number settings? I assume you can’t choose A1 or B2 then? If not do you know if it set to default pull setting and what it is? Thanks again. Love your videos. Very helpful for making a purchase. I have a 2014 TXI and interested in the VTX so trying to get informed.

Hey Matthew, do you have any Active or Inactive codes? Making sure the red lights are green should take care of that warning unless there is something else going on.

@@ChantelBoats I have noticed both inactive and active codes, sometimes the active code is there and sometimes its not

Yes - not a ton of changes with the screen from 2018 to 2019.

Is your rear ballast full and your Wedge down? I wouldn't go faster than 23mph (for a pro-level wakeboarder) with ballast full and the Wedge down. What model do you have?

Chantel Herbert my sports are Hydrofoiling, speeds 22-28 so need trim ability at those speeds Malibu 21VLX We also Stand up foilboard, speed 5-11

Ballast tanks. They fill up with water to make the boat heavier so the wake is bigger for wakeboarding or wakesurfing.

Chantel Herbert so if I fill the tanks all the way I will have a big wake

Zane Halousek yes

If you have them on your boat you should see them on the 7" screen. You just tap the circle and they should turn on. If you've had to reset your system for any reason, it may be grayed oput, so I would reach out to your service center and they can help you get the settings squared away.

I'm not sure what you mean - are you wanting to download the PDF versions of the manuals from the screen to your cell phone? Or the Water Craft Safety Video?