The other day some one asked how i would manually grind a radius. Here is a little tidbit
Пікірлер: 11
@jefflyon1007 ай бұрын
That"s an impressive setup. I was most suprised that the KO Lee could handle so much weight being swung off the load bearing area of the bed. . I have a bit smaller tool cutter grinder but my radius attachment design is also much smaller. After seeing this I'm going to go ahead and finish it up. I really the spring loaded center idea. I'm going to add a provision for that on mine. You filled in many blanks for me. Great video.
@grahamsengineering.25322 жыл бұрын
Very informative and interesting on how some of these jigs work.
@alfredlyon276 жыл бұрын
@brucegor here is our modified KO Lee and home made swinging device. Either between centers or in a 5C and one of our Accu-holds and we are able to swing radii within .0002" size and tangency.
@alfredlyon276 жыл бұрын
+brucegor please see my comment above
@edmondmkasian61734 жыл бұрын
I want ask you 2 things if you are able please make video for me Learn how change angles of HSS normal drill bit number 2 inch and grind it like hi performance carbide (with coolant flute) I mean i want Lean how grind it with 2 tip angle and narrowing phase of dtill for decreasing pushing force for penetrate to work pice, Secondly, i want ask you explain about your insert drill products, i don't know what type of products like gundrill you had been designed before this
@helldiablo84712 жыл бұрын
Yeah nah, i still dont get how you center the axis of rotation with the wheel edge ??? For the radius formers from the IG pic
@chefawan26636 жыл бұрын
Impressive work. Can we grind 0.4 to 0.8 mm radius ?
@alfredlyon276 жыл бұрын
Arshad Amin Awan absolutely, I’ve swung as low as a .127mm radius.
@chefawan26636 жыл бұрын
Remarkable
@edmondmkasian61734 жыл бұрын
Hi,i like your job,abd i only use your brand tools,,,,,