In this video we show you how to do a stock flip in Mastercam. Read our blog on it here mecadmfg.co.za...
Пікірлер: 12
@user-rf7gl9wf4d Жыл бұрын
Well detailed and explained, always struggled with this until now.
@mecadmanufacturing4980 Жыл бұрын
Thank you! We are glad this tutorial could help!
@user-yr7fl6zs1n10 ай бұрын
Now this is how a teaching video should be, you should feel after the video that you have learned something, excellent keep up the good work and make some more videos!!!
@mecadmanufacturing498010 ай бұрын
Thank you!
@kaydeamorbuye7316 Жыл бұрын
This tutorial was very helpful thank you
@Gusteru-on2wy Жыл бұрын
Right to the point. Great video, thank you!
@RaviK-n4t7 күн бұрын
Thank you sir 🙏🫡
@alexdementev6227 Жыл бұрын
Thank you for this tutorial! :3
@Cmtb12510 ай бұрын
Good video. Thank you for this.
@jenna-leewessels7139 Жыл бұрын
Lekker brother..
@haroldjoubert7816 Жыл бұрын
Mastercam does have a update jaws command you can use, then you can also customize the jaws to softjaws to exactly tha jaws you will want to use this way you can have all your fixture as per user requirements. Regards Harold Joubert
@mathewdasilva4421 Жыл бұрын
they need to update the stock flip with a way to change the jaws , becasue its very rare that you use the same set for op2 , since most of the time you turn soft jaws. Most of the time its ok but if op2 was very critical and you had to get close to the jaws it would be nice if they were very accurate.. thank you