A customer brought us this game that they received from a pinball hobbyist who performed a playfield swap and a cabinet re-stencil as well replaced all the circuit boards in the game with repros. However after all this work, the game just didn't play well. It looked great, it just didn't play well and sounded and played a bit worn out. This was due to old rubber being on the game, nothing rebuilt under the playfield such as pops, slings and flippers, no connector work done so much so that the connector pins would just fall out of there housings and or their poor solder crimps merely by a slight tugging on the wires. And no game play optimization after the playfield swap was completed. So we went at it and performed close to 20 hours additional work to this game to make it truly play as good as it looks. Buffed the chime bars and rebuilt them as well as the previous restorer used the wrong grommets on the chime bars so they "thudded" more than rang as they should. Also while we were so deep in the game, we modded the snake heads on the backglass to light up and blink as these always had the artwork there just no one at the factory thought to light them. As well as the lights in the red heads bejeweled top. Made those into blinkers as they should have been. =) Reach out to us at: drdavespinball@gmail.com if you's like a pinball machine restored or you'd like to buy one we have already done and have in stock.