Good job thanks for sharing! Yes I think many original parts were plastic and the replacement parts are metal ha. Like the Comand wheel internal pin.

To fix the issue you simply have to swap the two little black plasic pieces that the rollers slides on. Due to mechanical wear, they are at some point no longer able to keep the stalk in place. These are identical on front and back side so you can put the top one to the bottom and the bottom one to the top. When doing so, don't forget to lubricate the surface otherwise you will have to come back around auf year later, disassemble the whole damn thing again and then put the grease in for it to work properly. Ask me how I know! Also I think the premature wear that we are experiencing is due to a lack of grease, either from the factiry or because it dries out/goes away somehow. Hope this helps someone, probably a bit late for you but maybe it helps someone out who is experiencing the same issue.

thanks for share

Thanks à lot !

Thanks

Try, I know where is The "Problem" why switch is not standin in his position! don't need buy new one or second hand... you just need open Turn signal box 2.screw and change little black clips right to left , and left to right you can saw them 3:35-3:38, and it will be like NEW! ;)

This is a problem that a bmw owner will never face

Parler en français

Just buy a new one with warranty, only $99.

thank you.niw i know what i need to 3d print