Faulty Turbo caused engine to auto/over rev, a lot of blue smoke from exhaust fuel injectors damaged, cylinder 2 piston and engine bore damaged seizing engine...
Пікірлер: 41
@mercmantips5 жыл бұрын
The second hand engine we fitted is running very smoothly.. JOB DONE!
@hgulen505 жыл бұрын
I hope your channel grows and also your business too.
@yhshah213 жыл бұрын
You recon the chain jumped and piston hit the injector?
@thomashumber97623 жыл бұрын
I think these w212 Mercs are dogs- I hate mine on all counts- sooo cheap quality. I have owned my car for 6 weeks...in those 6 weeks more issues than I had from my old 99 w202 petrol in 10 years. Today my engine felt a little rough while doing 70 mph on the motorway- AND it lost some power... so I slowed right down and pulled onto hard shoulder and turned it off straight away and got it recovered. many hours later when it had cooled down I checked a few things myself as I know a few things about cars. I checked oil level (all good- it was 3/4 on dip stick) checked header tank for oil- seems fine) and so decided to start it- it started with knocking (not huge) but it knocked...turned it off straight away- then fired it up immediately- it knocked less and on tickover is quiet..rev it (1500 rpm) and it knocks. SO WHAT DO YOU THINK? OIL PUMP FAIL? INJECTOR FAIL?
@Tsxduden Жыл бұрын
timing chain could make some sound during startup on cold engine
@tonygarlingewarren74564 жыл бұрын
Just subscribed. Great channel this. Very useful and explained well. Keep it up
@skyrangerswift2ireland4 жыл бұрын
Nice work guys! Looking at buying a 2013 W212 soon. Keep up the good work!
@mercmantips4 жыл бұрын
Thanks for the comment, please subscribe 🙏
@skyrangerswift2ireland4 жыл бұрын
@@mercmantips I have. You deserve more! I'll pass it on to a few merc guys I know. Thanks!
@mercmantips4 жыл бұрын
Thanks alot for the support, there is alot more to come!
@thomashumber97623 жыл бұрын
DO NOT BUY ONE- THEY ARE CRAP
@josephalison15723 жыл бұрын
I experienced the same problem and had to rebuild the engine from scratch. It was oil sucked from the turbo worn out bearing into the air hose on the discharge side of the turbo.... but this in itself should not cause the damage because the oil would burn continuously... what caused the over-revving is the accumulation of big amount of oil in the intercooler which is located lower than the engine...then when you push on the accelerator this big amount of acculated oil is drawn towards the engine causing over revving (even if you turn off the ignition the engine continues to run until all the oil is exhausted)
@S-u-p-a3 жыл бұрын
Hello how hard do you think an oil pump change would be. Would it be an engine out job
@ganglittle84124 жыл бұрын
Where's your Garage? My Engine is making noise too...( knocking) that's what other garage said...How much is the new Engine??
@Michael-tg5uf3 жыл бұрын
ive got the same car with i think the same problem whats the cost to do this job ?
@user-fj3lz4lj6j5 ай бұрын
same thinks in w 204. c 200 cdi engine completely damaged at 475.000 klm. you think there is chance to happend by blocked DPF??
@jamesmullen2624 жыл бұрын
Wow that was a bad runaway, plus the higher rev limit from the remap didn't help. Is your preferred way to remove the engine, split the box and lift it out the top?
@mercmantips4 жыл бұрын
Yes defo remove the gearbox first as its rear wheel drive its very easy
@tomomofokeng90664 жыл бұрын
Good day mercman. C200 cdi w204 can you take engine out with gearbox attached from the top? Or its advisable to leave gearbox in if u using engine jack at home. Thanx
@mercmantips4 жыл бұрын
It will be near impossible to take engine and gearbox out together using an engine jack, this might be possible if you remove the whole front of the car (bumper, panels etc) i think it will be easier of the gearbox is removed first..
@tomomofokeng90664 жыл бұрын
@@mercmantips thanx. I dd remove everything and took out the engine with the sub frame. The other thing my power steering pump is having wierd sound, was advised o change oil but seems like it not oil because they old it its original oil. Considering new pump. Any idea?
@troyhoang36775 ай бұрын
Do you have to program the new injectors ?
@BigHumz1554 жыл бұрын
Hey MercMan, how possible is it to swap an OM642 in to a W212?
@mercmantips4 жыл бұрын
I have never removed an OM642 but i guess it cant be that hard
@BigHumz1554 жыл бұрын
@@mercmantips Well, if my 651 ever goes bad I might actually consider it as a project 😅
@azeddinebabeker92334 жыл бұрын
Thank you for the video and I want to ask you about the engine OM651why this engine has a problems specially in the crankshaft? Thank you
@mercmantips4 жыл бұрын
Hi, these OM651 engines don’t really have a problem with the crankshaft much, the main problem with these engines is the timing chain...
@MobilediscowirralCoUk4 жыл бұрын
MercMan Tips does the w166 have same design from om642 or updated engine all together would you say keep with ml350 or ml250
@fctuning2 жыл бұрын
Where are you based dude?
@Autofanas7775 жыл бұрын
What was the mileage??
@mercmantips5 жыл бұрын
Original mileage was 86,000 miles, but the car has been remapped, so possibly caused because of the remap and some harsh driving!
@hamadyousef87284 жыл бұрын
So you took the engine and the transmission together from the top ?
@mercmantips4 жыл бұрын
No gearbox out first, then engine out, just my preference
@hamadyousef87284 жыл бұрын
@@mercmantips hmmm i will figure it out tomorrow which it is better .. took them together or separated!! Thx by the way for the reply 😁
@mercmantips4 жыл бұрын
@@hamadyousef8728 no problem let me know how it goes! and why are you removing the engine?
@hamadyousef87284 жыл бұрын
@@mercmantips the engine and the transmission with the subframe all down because it's easier .. because the engine does not rotate i don't know the reason yet
@mercmantips4 жыл бұрын
@@hamadyousef8728 most likely timing chain problem valves damaged! very common problem on that engine
@19Loggie914 жыл бұрын
With all due respect I’d say you’re wrong, these engines are known for injector failure and I’d more than likely say cylinder 2 injector failed causing the resulting damage. Just my opinion
@mercmantips4 жыл бұрын
Well in these circumstances you can never know the exact reason why it happened, so you could be right, but in this engine there was a lot of oil in the intake pipes...