Respekt 👍🏻

Great video, thanks for good camera angles, must have been some handy work.

Perfect timing. Thank you so much for sharing. Just going to get my air compressor out to change 👍🏻👍🏻

Learning!!!! 👍

Thanks Howard Tomlinson for the information about this! Guys wanted to show how soaked and dirty these sensor got under the bumper. You should really clean it under before you start. It’s not hard to understand why they broke after a while. Seems that newer sensors model got plastic cover now, the old only had silicon that goes bad faster. Hope you enjoy had hard time to get good video shots. You should look under your car it may depend on your equipment if you can change them all without removing bumper. Unfortunately the bracket that holding the sensor has going loose that’s why it’s not lining up. Need to remove bumper and do a proper fix. If you like to have closer look how they hold in place you could see this video kzfaq.info/get/bejne/Z9lzp7Sa27q-c4k.html

What about the front ones?

I got a curb and my sensors moved around inside and I don't know if I can just pop them back in

👍🏻💪🏻👍🏻💪🏻👍🏻💪🏻👍🏻💪🏻👍🏻💪🏻👍🏻💪🏻

I bought a new sensor and can't get it to fit in the adapter. It is the same part number as the old MB sensor, but it won't slide into the adapter. ........was hoping this video would show that, but it is skipped.

So I’ve replaced all the sensors and they still don’t work. Also, the blindspot on the side mirrors stopped working as well. Any thoughts? Module??

So i changed my sensors and right after some turns it stopped working it worked for a bit but now they dont work what could be the problem?

Man sieht nicht wirklich wie es geht, schade.

My 212 doesn't have any sensors.