My pleasure. Thanks, Alfonso. This is why I make these videos.

Thx.

Thanks, MrPhymed. Yes, the goal is to keep these wonderful cars on the road as long as we can.

@@masood-tv did you need to calibrate them using a scanner after you installed them?

@@MrPhymed no, not at all. Please watch the last few mins of the video to see the sequence of what needs to be done.

Thanks, Roger.

Hi Michel. I think what I said was that once you have replaced the bad strut, you have restored the ride to its original factory quality...please listen again. Thanks.

Thank you, sir.

Thanks, R M.

Thanks, Allan.

Hi Frinly, I believe it is either 8mm or 10mm - I don't remember exactly. With these cars, it makes sense to have a metric socket and wrench set covering 7mm to 21mm...

It depends....I see them from 390 and up...check out FCPEuro.com and Autohausaz.com...also Pelicanparts.com

Hi Andrew, thanks. Yes, I am. And, FCPeuro provides lifetime warranty..

@@masood-tv Thank you sir

@Andrew Silverman , np. I do have a video of the rear shock replacement on these cars also when the time does come. Thx.

i recently changed the front shocks with a friend following your video. Thank you, it worked terrific. A real sense of achievement. While inspecting the undercarriage, I noticed a few seals towards the rear that seemed a little wet. I would like to change those seals or gaskets however it looks as if I have to lower the muffler and the exhaust brackets look rusty and should be replaced. Have you ever had to do this? Any input would appreciated. Again, I apologize for the wordiness. Thank you as always.

Hi Faizy, you can unplug the connections or remove the bulbs.

@@masood-tv I removed the wires to the SAM but now the lock is not operating. Can I manually lock the door or will it cause damage to the vacuum system? Thanks for your advise and wishing you a HAPPY NEW YEAR 2023.

@Faizy Murtaza I wish you the same and thx. No, you can use the key and and the vacuum system should be ok.

Thanks, matsujarvinen.

Thank you.

Hi Milk Man - no, I don't. But, there is a company in Europe you can try with much better quality shocks and good warranty: aerosus.com/. If you decide to go that route, please share your purchasing experience here so others may benefit.

@@masood-tv Thanks! This seems reasonable. Are they higher quality than the Arnott or somewhere between Chinese and Arnott?

@Milk Man they stand behind their prroduct for, I think, 2 years. In par if not better.

Hello Igor, I did not omit any procedural steps in the video. No need for Star.

Please go to 0:48 second of the video.

Hi Shannon, I am currently in NY.

Sorry, will definitely keep that in mind in future videos. Thanks for the feedback.