Mini bike cam comparison
Рет қаралды 7,182
8 ай бұрынMini bike cam comparison
Tested the Volts.330 cam against the GoPowerSports Fire 265 cam on the Tillotson 225-powered Mega Moto 80/105 mini bike
212 Ghost kart racing engine playlist - • 212 Ghost VS 206 Brigg...
Mega moto e-bike playlist - • Raced the QS120 e-bike...
Predator 224 playlist - • Predator 224 gets a 26...
Mega moto performance playlist - • Mega Moto 80/105 unbox...
Bonanza minibike playlist - • 1.3 ratio rockers vers...
Coleman cc100x Predator 212 playlist - • Free Predator 212 perf...
Road rebel go kart playlist - • Kart vs scare chair / ...
Coleman cc100x/DB003 minibike micro bike playlist - • Will a Trumpet exhaust...
Coleman cc100x playlist - • Coleman CC100x Minibik...
Doodlebug playlist - • Is the Doodlebug minib...
Coleman CT200U-EX playlist - • Coleman CT200U EX mini...
Azusa minibike playlist - • Is a Ghost faster with...
Coleman CT200U playlist - • Coleman CT200U minibik...
Predator /Tillotson playlist - • Free Predator 212 perf...
Minibike playlist - • Mega Moto 212 goes 60 ...
Subscribe for more minibike content: kzfaq.infofea...
Instagram - Doubledown555Black66
Don't forget to leave a comment to let me know if you enjoyed this video! :)
*********Disclaimer*********
Please do not try to re-enact or recreate anything you see in these videos.
Black66 does not take any responsibility for injuries or equipment failure created by doing so. The following video features activities performed in controlled environments by knowledgeable persons. DO NOT attempt to duplicate, re-create, or perform the same or similar activities at home, as personal injury or property damage may result.
ALL BLACK66 CONTENT IS FOR ENTERTAINMENT PURPOSES ONLY.
@SDS-1 8 ай бұрын
The Fire 🔥 burnt that tire right OUT!!!
@freeradical6390 8 ай бұрын
You have the best minibike mod vids on utube! Straight and to the point, never trying to sell me stuff.
@racerothery2716 8 ай бұрын
I’m getting myself a few gears to play with for my 240cc small block build(59mm stroker crank) I have the juggernaut and the juggernaut upgrade kit for higher RPM so I got myself a 37 tooth for the rear and 10 on the torque converter . So I’m gonna get a 50 and a 56 and play with it. I wanna be able to hop on the highway if I plan for it and keep up without topping out so bad that I have to back off constantly. I’m hoping with 240cc I can pull a 3.7 gear ratio and get it up there around 75mph
@andrewkuhtz 8 ай бұрын
I think its gonna have more top speed then the 330 cam…i will say 68mph…you got really lucky with that flat tire dude😳. Thats the only thing i worry about while doing a top speed run is how long will these tires hold up for???
@Spacecruizer203 8 ай бұрын
I wonder what cAm I need fir my Ducar212 🤔
@cohocarl 8 ай бұрын
Good heads up with the tire. Glad it ended well.
@AquaTech225 8 ай бұрын
Man I need me one of these. To cool
@NVScrapper 8 ай бұрын
What an awesome video! Too bad your tire blew 😅 be careful out there! ❤
@Strict30 8 ай бұрын
Spring install height is key to the rpms
@Black66 8 ай бұрын
I have a video coming out comparing different spring install heights on a given combo.
@Ultimatrix117 8 ай бұрын
I think at the very least it would have about the same top speed but definitely can't wait to see follow-up video
@Spacecruizer203 8 ай бұрын
I'm gonna do a speed run on my bike this weekend I hope it comes out good I'm gonna try not to talk as much just get right to them numbers 💪🏼💯💨💨💨💨
@muddywaters2975 11 күн бұрын
New subscriber and trying to watching all Your videos . I have a honda gx200 and would like your recommendations on a cam for this Motor. Thank you for all your hard work
@RowansTalkShow 11 сағат бұрын
I just want to know where can i find the cam because your cam links aren’t working!!! Please!
@Black66 9 сағат бұрын
GoPowerSports
@RowansTalkShow 7 сағат бұрын
@@Black66 name of cam and size for 98cc
@screwdriver3657 28 күн бұрын
What speedometer app do you use?
@Black66 28 күн бұрын
I use a Dragy performance meter for 0 to 30 times and digiHUD on the phone for top speed.
@336MiniMafia 8 ай бұрын
What kind of motor mount is that? Also will it accept a torque converter on that frame?
@Black66 8 ай бұрын
Check out the Mega Moto 80/105 playlist for the build videos and parts links. Part links are in some of the video descriptions. kzfaq.info/get/bejne/rrxonJhqxq25kaM.html
@hellheart1993 8 ай бұрын
If i was there all u gotta do is call me up and id pull ya home, i think the top speed is gonna be like 67mph
@TanBoiIndustries 8 ай бұрын
How did you do the motor mount setup on that motor?
@Black66 8 ай бұрын
Check out the mega Moto playlist for the entire build kzfaq.info/get/bejne/ed9_nauakr2plHU.html
@flatearther5780 8 ай бұрын
Yo Black 66 I made it to where the govenor is pulled all the way with the hand throttle on the Doodlebug stock how would I make it faster what clutch would be the best that would fit a stock chain?
@kylesyx8432 8 ай бұрын
Get you a 60-65 tooth sprocket on back That should give you about 10 mph faster Vm22 slide carb 32$ Header pipe and exhaust 35$ You’ll double the speed and power
@flatearther5780 8 ай бұрын
@@kylesyx8432 where would be the best spot to purchase the sprocket and would it fit the chain for the Doodlebug?
@greggory448 8 ай бұрын
How is that cheetah Clutch treating you. ?Is worth the price?
@Black66 8 ай бұрын
So far so good
@ianfairbanks1318 8 ай бұрын
the 265 SHOULD be quicker, it has less duration which means more low end torque. It's why i run a stock cam. I can DESTROY most bikes off the line with the same gearing as me.
@nickrupp2336 8 ай бұрын
Now ya need to start playing with a turbo on one of those bikes.
@dabtech7456 8 ай бұрын
Can't . Turbos need an oil pump and oil cooler other wise it will burn up or just super heat the oil and the motor will blow plus they don't have enough exhaust flow to power one . .there was a guy who put a turbo on a predator vtwin and it barely made 3 hp over stock lol
@PrinceoftheLightSkins 8 ай бұрын
They both do 60's. Bigger cam needs more valve spring pressure perhaps 55lb or 60lb duals with a slight gear drop for that big 330. No way the cam can spin 9k+ and i'm only doin 60.
@Black66 8 ай бұрын
Both cams used the reccomened spring package. If a lower gear ratio was used you could get a lot more RPM out of the 330 cam than the bike was turning with this ratio in this video.
@bikelifecincymini 5 ай бұрын
What's best cam for drag racing?
@Black66 5 ай бұрын
That is a matter of opinion and dependent on the engine set up.
@Sweetersweet2006 8 ай бұрын
Can a electric one be registered to be street legal
@MrLopez-lm4jk 7 ай бұрын
Does anyone know why my 275 cam bike with stock billet rod and 22lb springs is slower then my stock cam bike??? both same gearing. Do i upgrade my 1:1 rockers?? Cuz i thought i didn't need too.
@Black66 7 ай бұрын
I would say it's about the combo. If the parts arnt there to support the bigger cam then it most definitely could be slower.
@MrLopez-lm4jk 7 ай бұрын
@@Black66 billet stock rod & 22lb honda valve springs
@MrLopez-lm4jk 7 ай бұрын
Ducar 212
@thomaswestwood5227 8 ай бұрын
put a 459 in one of your bikes get those big blocks going
@racerothery2716 8 ай бұрын
As for the top speed on your bike,… I’d say 5mph faster tops. I’m using a GPS welded lobe 260 duration 285 lift cam for my 240 and I have 1.2 EC Rev Rockers so I’m hoping to put some power down and try to match some of your times. Get my cam from GPS and let me see what your motors can do with it
@racerothery2716 8 ай бұрын
Hey has anyone tried to do a mountain bike gear stack on a mini bike? What’s different about that that makes it so we can’t just use one with the gear switch off the mountain bike and everything?? Seriously I wanna know because it’s haunting me
@samaxeman123 8 ай бұрын
Been thinking the same thing.. I’m sure it could potentially work
@racerothery2716 8 ай бұрын
I thought about it more and it would have to be made but the idea is already there to make it off of. Just needs to be made for 40/420 or 35 chain and spaced properly for that and I’m certain it can work. I’m sure someone is already working on cashing in on that idea. Someone with the means either needs to or hurry up with whatever they already started
@Spacecruizer203 8 ай бұрын
Probally be faster if u lose the heavy brake pads and go with the parachute lol
Red Beard's Garage
Рет қаралды 91 М.