What’s the biggest mistake you've ever made buying wheels + tires? - bit.ly/3kuTdOM

Biggest mistake I see everyone make. “I thought they’d look bigger” Start with the biggest setup you can afford. They look a lot less aggressive in person. Especially when you see someone else’s BIG setup next to yours. 😎

I made the load index mistake so when I needed to get the tires turned around on the wheels because somebody mounted the wrong side wall out (damn it, Carl) the local tire shop wouldn't service them on my truck. I had to take my floor jack and jack stands with me and take the shoes off my truck in the parking lot.

Hats off to the folks who mount and balance these beautiful wheels. I used to be a tire tech and I'd be too afraid I'd scratch them 😅

My worst one: not spending a little more cash and getting A/T tires on my first truck’s wheel setup. Went with all seasons and regretted it (got A/Ts after they wore out).

I personally work at a tire shop where i live and i will be the first to say that yes we do takecare of all wheels and tires especailly if there new. However it is possible for something maybe to be in the wrong position and put a nice scratch across your brand new Akrons. I would strongly recommend letting them do the mounting and balancing for you cause in the end if they damage they will replace. Seams like a win in my books.

I recommend following Dustin's advice

My fuel contras (24x14) are arriving in 7 days, I’m wrapping them in a set of 35x13.50 r24 venoms a/t for a little bit of a stretched look on my Jeep. I hope it goes well

I just bought the Venom Power Terra Hunter XT 33x12.50r20 load rating 119, they drive really well, I notice that on the tire cold it say 80 PSI, my TPM in the Silverado indicate 40 psi, I just got them installed, so my question is at what PSI you keep yours cold?

Im putting 2.50 leveling front, 2inch rear leveling kit on 2022 z71, it has 20x9 factory wheels. Will 33-12.50-20 fit and what off set do i need for poke to be 1 inch or less outside of fender?

rotiform jdr on my f150 the hub bore is the same and bolt pattern is the same should i send it and get a set

i have a leveled 2016 ram 1500 4x4 with factory 20x9 wrapped on 35x12.50x20 and i want to purchase some wheels and want to go with some 20x12s -44 would it actually rub more cause i had to trim a little ?? thanks

My biggest mistake was slapping 2021 20x10 wheels w/295/45/zr20s on my 2016 durango R/T which cause them to kung fu my stock suspension control arms until I figured it out after a couple drives. I went down to some 275/45/r20 grabbers which don't guard the 10" wheel from potential curb rash the same but they fit the under the front arm since I wasn't sure about 285/50/r20 without a lift kit. I'm just studying suspensions & don't see much feedback about that size without a lift.

Bought a set of wheels and tires one time for a vehicle didn't take into consideration the offset. So they mounted closer to the suspension than would have liked lol. Lesson learned

Biggest mistake- not checking the lug dimensions first and got something that didn’t fit so had to get adapters

If I buy tires and wheels and have you Mount them. What do I do about my Factory TPMS?

How do you know the hub of your after market wheels will fit for sure?

Haven't made a mistake yet, hoping not to due to here soon gonna be buying my first set of wheels tires and my suspension from Custom Offsets. Watched every video posted just to make sure I can fit what I want and will run the way I'm hoping.

hello i was told if i put bigger than a 22 inch rim on my 2024 gmc 1500 slt my front end would go bad and gear ratio change

I like this guy because he has a Charmander tattoo and that automatically makes him awesome 🤘🏽

Dustin is a beast in front of the camera! He needs to be hosting TMZ or some shit!!!!! 💯

Can you guys get fury county hunter mt 33x14.50x24 tires? I haven’t seen them on the website in months..

Is it safe to use Hub Centric rings for my wheels when off roading? Center bore 77.8mm to 110mm

Looking for some 26 in flat wheels for Ford. F250 no poke out no lift

Just got my wheels n tires 8 days after ordering. Couldn’t be happier with the service.

Looking for some 24-in flat wheels for a 2004 f250 8 lugs

My biggest mistake was letting my local garage put my tires on my new wheels, did great putting them on, not so much taking them off, scratched to hell in the first 6 months ive had them, im going to be touching up the paint on them myself

And here I am, just received my new wheels today… let’s see how this goes

Getting a 7in lift kit with 24x12 tires on my 2018 Chevy Silverado 2WD do you think it will rub ?

my mistake was not ordering from custom offset but really is hard to find a affordable 20 inch for 1980 chevy c10 5 lug

i have a 02 ford ranger and i don't want to blow money on tires then have to get a lift

Welp… drove an hour after convincing the guy to sell me wheels and tires he was gonna sell to someone else I paid extra thinking they were pro mags they were actually black painted trailer wheels and tires. I was pretty bummed now I’m stuck with them(:

dustin is really good at his job lol

Biggest mistake was not knowing the correlation between load index and load range. My truck calls for Load Range D but does not specify load index. So I got some 35x12.50R22 117 Load index Load Range E, thinking they would be fine. Well, they would be, if I wanted to run them at 60PSI. But the factory tire pressure is 42PSI. So for this size, I need a 127 Load Range F. Why F? Because all that the letter indicates is the maximum acceptable pressure. For example, the 121 Load Index Load Range E has about the same load capacity at 42PSI as a 127 Load Range F. This is because the load index is calculated at the MAX PSI. For LR-E it is 65PSI for tires like these, and LR-F is 80PSI for tires like these. SO when you do the calculation, a 121 Load Index with Load Range D has MORE load carrying capability at the same PSI than a 121 Load Index with Load Range E. This is because the 121 load rating is now measured at 65 PSI rather than 50PSI. The only benefit from a higher load range is that you get to run the tire at higher PSI and because of that, you end up getting more load carrying capability. but ONLY NEAR max PSI. So now i have to dismount and remount new tires and rebalance that meet the load carrying spec for safety.

Biggest mistake was thinking I knew what I was buying when I didn’t because rn I have 20x10s but they are going to be my winter wheels and I already have my 24x14s ready for summer

Hey guys how are those venom tires Are they loud? And how are they in the snow and in the rain?

I’m glad I watched this video. Might have avoided a big mistake. I bet a lot of ppl wish they saw this before they bought wheels and tires.

Biggest mistake I made...not getting enough double stuffed OreoS! On a side note...looking for a nice set of wheels and tires for my F350 4x4 C C. L.B. I will know them when I see them

I bought a set of 35 16 16.5 boggers and I mean no one would mount them for me I had to go to a semi tire shop to get them mounted

Can't wait for my wheels! Someday lmao

That I could of just bought a leveling kit to fit 35s on the truck

Should have gotten 17s with less offset instead of the 20s with the semi aggressive offset that I did 🤷‍♂️

Biggest mistake? I should have bought 22’s or 24’s instead of 20’s🤷🏼‍♂️

Biggest mistake that I made was when I thought I could put truck wheels and tires on a car!😂 A big WTF moment!

Noti Gang late af! 🤦🏾‍♂️

Biggest mistake I ever made was buying super swampers for my daily driver YJ.

Noti gang pt5

Dustin my guy when you gonna fix the missing part that separates your headlights messing with my ocd

I just got 22x12 to sit inside a 35x12.5 6in lift

Damn Dude you bounce around a lot!

Always buying smaller than I want lol 😆

Mistake was buying cheap tires , nitto and toyo from here on out

I need to make payments lol on some 24x12s

I'm surprised bolt pattern isn't in here. But pros likely wouldn't make that mistake I suppose.

What's wrong with the Double Stuffed OREOS ? Great video !

Going to a non reputable shop to buy wheels and a lift I had a 3 inch lift and 20x8s after I paid for 20x12s and they wouldn’t change them or give me my money back 😂

I bought a set of rockstar rims. Enough said.

That’s a nice Justin fio hat 🧢

Yall be taxing on the tires 😂

Mistakes I make. Watching videos that take 7 minutes to even get to the point if the video. Lol. Jk. Great video man.

Fabtech's proprietary technology for their front shocks/coilsprings

This guy is the shit

This whole trying to find out what tires real diameter is confusing. Then you go to gallery and you have guys running the exact same setups one says minor plastic trimming other one says major metal trimming.

Dont forget speed rating...

Yessir

Can Custom Offsets be contacted for a free quote?

👍👍

Hi

Bro, you look like that guy from pawn stars Cory.

Dude is way to hyped.

Leave me and my double stuff oreos alone.

Day 92 of asking custom offsets for a company dually truck build

What the heck is wrong with double stuffed Oreo'S?

There is no point in balancing a checkbook in 2022... it's called online banking.

F 12ply 🤟🏼

The dude needs a rehab stay for white powder.

My buddy made a mistake. He said he wanted a Toyota tocoma

church? lmfao lord and Flavor cheese and rice

Too big offset

I can't remember the last time I got taxes back. I am one of the few suckers that actually has to pay income tax. Pisses me off. All these people saying I need to pay more when they pay none. Sorry man just drives me nuts- BTW if you are getting money back instead of breaking even you are doing it wrong. Only mugs give the govt their money to hold on to- Everytime I see someone bragging about getting a big tax refund every year I just want to tell them how stupid they are for doing that and I lose respect for them

Another one that no one tells u big wheels example 24X14 is fucking up ur suspensions 🤦🏻🦅

The woes of a mall crawler... So sad

Those lifted trucks on low profile tires look so stupid. Biggest mistake you could make.

Did Dustin get new tattoos?

Day 136 of asking co for black and milled davincis

Biggest mistake, buying tires not know not all run true to size

Not looking for a crack on the lip

Is having a tax professional file ur taxes and getting you more money legit

Venom = junk

Bought Federal Couragias.... RARARARARARARARARARARARARARA.... sumbitches are loud AF on pavement.

Dang get off the caffeine. The content is good but I can't take the yelling

Make side walls great again. It’s as if truck guys are going through the early 2000s fast and the furious trend. 🤡🌎

Do you guys ship wheel and tire packages (mounted and balanced) to Canada?