Best video on this subject. Everything explained and shown. Thanks for taking the time to help.

Great commentary, to the point but with detailed explanation. A lot of people doing these videos automatically assume that everyone is familiar with pulling panels and running cables through firewalls. Your videos give people the confidence to get a kit and have a go themselves.

Thanks for this video. You must have the smallest hands of any known body. It took me about 2 hours to get the wire through the grommet. I ended up putting a flat screwdriver through the grommet to give a space for the cable. There was not room for two hands between the brake actuator near that grommet. I did contemplate putting a hole in the grommet but persisted and it appears to work. The hole in the rear was the easiest part.

Great video, very helpful. After installing one of your excellent kits (without breaking or losing any factory clips, thank you again) I reckon I know how the installer got that cut on his left hand as well, the underdash of the pajero sport has some sharp bits hey.😁

Brilliant video. Thank you for taking the time to create and upload it for us. When I receive my Pajero, I'll be ordering everything from you. 👍

Great video, helped me figure out how to run wiring kit for my DCDC charger. Cheers!

Thanks for the videos.....huge help

Really helpful. Thanks heaps.

Hey mate good video and it's so helpful ...just wanted to know how to route the cable if I want to install the Anderson or accessory unit near the back bumper as I want to use Anderson for my trailer

Excellent video with all the detailed description / camera close ups!! Subscribed! :) Can these accessory wiring harnesses be bought as is for the Pajero Sport? Or need to make it yourself? Does the vehicle battery connect to the redarc which then connects to the auxiliary battery to charge it? I’m trying to decide whether to do a second under bonnet battery to power fridge etc; using a LiFePo4 / Redarc BCDC1250D, or if I should just buy a portable battery pack instead - any thoughts on this?

Do you by any chance know which is the speaker wires?? I can’t find any, took off the passenger trim floor and cannot figure out which one to look for. Need left rear back wire colors so I can tap into them

Great video mate. I’ve watched the battery tray video but can’t seem to find the video you mentioned about the red arc mount? Cheers.

Is this the same installation steps for the QE (2016+) model - compared to the QF you do in the video?

Is there an earth wiring location or bolt in the back somewhere?

Where do you buy all the accessories from.