Well Done, Billy. Remember, spacers move the wheel further out, increasing the moment arm, thereby "softening" the spring. Also, I'm surprised you did not measure the ride height from side to side when taking your initial measurements... but perhaps you did. But right now, I gotta go get ready for a hurricane. Later.
@Billy_BuiltАй бұрын
@@dannoyes4493 never really thought about how it affects the softening of the spring. To be honest I always thought about it as being an extension to the wheel. Much like a lower offset wheel would have. I measured all four corners. Just found it redundant to shove into the video lol. Best of luck to you sir with the hurricane.
@Billy_BuiltАй бұрын
Hope all is well with you in Texas after that hurricane!!
@dannoyes4493Ай бұрын
@@Billy_Built Just returned to the land of the living... Thanks for the kind words - BTW, all cars are A-OK.
@Billy_BuiltАй бұрын
@@dannoyes4493 Good To see it!
@celica-dragons7035Ай бұрын
🔥
@kosmashionidisАй бұрын
I would have gone with black mesh wheels
@Billy_BuiltАй бұрын
@@kosmashionidis I can't stand black wheels lol
@rudimerm7686Ай бұрын
Billy, are there schematics of the wiring online? Great choice of wheels, which are a game changer.
@Billy_BuiltАй бұрын
@@rudimerm7686 there is. I'm pretty sure i had found some at one point. But this was just basic electrical fan wiring, so didn't necessarily need it here.
@salvatorelb1338Ай бұрын
So much better! (Wheels) loll
@aaronpuchalla5261Ай бұрын
I had a blk 86.5 na. Super slow. 17sec 1/4 mile car lol but loved that car. Were your door moldings painted? Mine were a gold with a strip pattern.
@Billy_BuiltАй бұрын
@@aaronpuchalla5261 fairly certain they were painted along with the entire vehicle. Yeah they are not very fast from the factory at all. Even the turbo model only makes about 200 at the wheels. But the engines are quite capable. There are a few around making well over 800 horsepower.
@kheangnou8582Ай бұрын
sawblade wheels looks better imo
@kosmashionidisАй бұрын
And BTW change your barber!! Get one that can see😂
@Billy_BuiltАй бұрын
@@kosmashionidis listen.. I know. I know 😏
@ma70cxАй бұрын
Nice! I have the same supra & currently running NA A80 supra wheels like you too! Do you have problems with the front wheels scrapping in the inside when making sharp turns? I have that problem and I don't have any spacers on.
@Billy_BuiltАй бұрын
@@ma70cx I had some minor rubbing going on with the factory wheels. I think it might have just been a loose fender liner honestly. Haven't looked too far into it yet though.
@Billy_BuiltАй бұрын
@@ma70cx That was only at full lock too
@TheHighroller88Ай бұрын
can anyone tell me what brand the front bumper is iv been looking for that style for years
@Billy_BuiltАй бұрын
@@TheHighroller88 I'll just tell you, it's the kaminari.
@jennaturner555021 күн бұрын
What coilovers do you have?
@Billy_Built21 күн бұрын
@@jennaturner5550 no clue, no markings, car came with them.