Done on my 17 Alltrack. Other MK7 MQB platforms are similar if not the same. I replaced the bearing about 2 months ago and have about 1500 miles on it.
Пікірлер: 20
@theripper1213 жыл бұрын
Thanks for the video. My father has a mk 7 gti and the dealer wanted something crazy like 700 just for the labor. Watching this video I have no doubt I can do this in an hour or two.
@MLeung-vl7we10 ай бұрын
Got to do this on my MK7 shortly with 72k. Instead of guessing, with a marker, mark a slash on the bolt, and then another 180 degrees on the wheel. That way you can reset the breaker bar to its max leverage point without thinking about the position of the handle. Thought you might have stripped that last triple square. I always clean it and tap in the bit so its fully seated. Turning the steering wheel to the right for more access was a good idea.
@danyo1972 Жыл бұрын
200nm applied with car off the ground, then the 180 degrees on the ground with someone with their foot on the break pedal. Failure to to do so could damage wheel bearing.
@raymondphan38065 ай бұрын
Great job .. . .. :)
@IsabelTSMusic3 жыл бұрын
Any further tips on getting the axle to come out? I pounded on mine with a socket but it won’t budge and I’m not sure how to proceed. Does it need to be at a certain angle? I’m afraid to keep hitting it hard since a damaged axle is the last thing I want.
@ChadTobin2 жыл бұрын
Did you have any lights come on the dash ? My 2016 jetta trendline + has a abs light airbag light traction control light and a steering warning light and I took my car to a shop that only works on vws the said it was due to the left rear wheel bearing and abs sensor 450 to be replaced. Car has 107,000 kms
@shawnoen10293 жыл бұрын
What brand of breaker bar is that? I like how it supports itself around the head. My Snap On doesn't even do that.
@scirockalot8v3 жыл бұрын
Harbor frieght. I haven't broke one yet.
@kreidosdaddelt1196 Жыл бұрын
Du hast ein Problem und zwar sieht man, dass deine Antriebswelle bereits Wasser gezogen hat. Das erkennt man daran, dass das Fett aus dem Loch von der Schraube der Antriebswelle rausläuft und viel zu dünnflüssig ist. Du solltest deine Antriebswelle auf Beschädigung überprüfen und ggf. tauschen. MfG Ein Deutscher Mechaniker
@dasauto446 ай бұрын
how many miles did it have before the change>?
@scirockalot8v6 ай бұрын
30,000 some odd miles
@dasauto446 ай бұрын
@@scirockalot8v I have a 2017 gti. Still rides like new. 140k
@rmc52783 жыл бұрын
Hi sir how many miles was on your car when you replaced the wheel bearing ? , Thanks.
@scirockalot8v3 жыл бұрын
Little over 30,000.
@tonyd32663 жыл бұрын
@@scirockalot8v german engineers now spend their time trying to engineer failure 10K after the warranty runs out, I swear.
@danyo1972 Жыл бұрын
Mine has 225k miles on it and still on originals. A bad pothole can destroy a bearing. Once moisture gets in it’s ruined.
@tonyd32663 жыл бұрын
I learned to get the 12mmspline bolts out with knuckle on car. then re-install tire with1 bolt and kick tire on opposite sides and ive had one ton trucks to VWs always pop out without pounding back there. -- your bearing looks shot.
@danielschroeder72033 жыл бұрын
Is there a secret to reconnect to the control arm?
@itsaperionasentinel5446 Жыл бұрын
I put a jack underneath the newly replaced bearing and jacked it up a little bit so that the control arm had room to move up into place easily