MN Model MN99S D90 First Run and Recommendation

Рет қаралды 322

22 күн бұрын

I finally did it and invested in an MN99S for the channel. I have plans and thoughts.
Table of Contents:
00:03 - Introduction
01:09 - First Thoughts
02:59 - Outsoor Crawl Test
04:03 - Results
05:02 - Bench Test
06:57 - Marker

Пікірлер: 5

@BillsWorkbench 9 сағат бұрын

Make sure to check out the review on Version 2 MN-98 / MN-99S. kzfaq.info/get/bejne/sJ-FoMh_stnHdGw.html

@s737500 20 күн бұрын

Looks like the esc is shutting down beacuse of overcurrent draw. Have you tried to run it in ? Just drive it around a full battery or two just to loosen it up, and break in the motor ? The control board might just be faulty too. I have one of these in the mail on the way :-)

@BillsWorkbench 20 күн бұрын

I swapped out the radio/ESC for the one in the MN82 and it worked like a charm. So it must be the electronics module. This last weekend I swapped out for a RadioLink receiver and a cheap ESC. (Video coming soon) It does seem to be working better, it is still "under powered" as it stalls. I don't think it's the replacement ESC because it will get over if you give it full power. The old electronics module would not do that. With that said. The MN99S platform is a nice little platform if you like to tinker and upgrade. I plan on getting my 3D printing skills up to the task and make some modifications that will hopefully get this little guy up and running like a champ. I have lots of plan for this crawler. I am interested to learn how yours performs. Please let me know.

@coreyfuchs730 Күн бұрын

Some of these cheap rc vehicles seem like a waste of money😂

@BillsWorkbench Күн бұрын

Yes and no. These are fun if you are looking for a platform to tinker with and break-fix-repeat. On the other hand, there are cheap RC vehicles that are indeed a waste of money. Hopefully, this is part of your pre-purchase research, so you know what you are getting into.