I made the same thing using the same packout vacuum, Packout deep tool box and Milwaukee router. Mine is a bit smaller and I 3d printed the cleats to install on the bottom of the 3/4” ply so the entire surface locks into the Packout and won’t slip off. Also my fence is horizontal orientation instead of diagonal. The Packout cleats model can be found on thingiverse fo free! I have also modded my packouts quite a bit. 3d printed Milwaukee and DeWalt power tool cleats mounted to inside walls of Packout so my impact driver, impact wrench, drill, router and all 20v and M18 batteries slot into the sides. This stops them from rattling around in the box whenever I go over speed bumps. Also printed the cleats for another 3/4” ply that my job site table saw is mounted on so it can also be placed and used on top of my Packout stack. Currently printing an extension cable rack that connects to the aluminum rails on the corners of the Packout. Great idea and great video!

Kinda wondered where this was going, but what an incredible result. Thanks for sharing. Makes me want to get the m18 router now

Well shut the front door. I am making this hopefully this evening and had watched this video about a week ago.but stopped just short of the end. Watched again just now to confirm materials knowing the whole time you was making it to set up and use on top of pack out, not once had I ever thought about stowing it in the pack out on the wall. Awesome dude

Just watched it again... Plan to make this over the weekend! Thank you!

Very inspiring! This gave me an idea to use a packout worktop as the table!

Gotta love the ubiquitous Irwin clamps 😁

That’s awesome! Great job! Very creative.

Been watching, had to subscribe. Thanks.

Love it! Another one I will build

love it brother, nice work

Thanks for share this great idea 💡 you are so awesome 👌 wow 🤩👏👏👏👏👏

AWSOME CREATIVITY. IM MAKING ONE.

Dude you are becoming my favorite !

Now that’s a great video

Мобильный, независимый фрезерный стол MILWAUKEE PACKOUT 🔥😊👍

might i suggest that you check out izzy swann and his router table fence. a "channel" for the fastening screw and a pivot point at the other end will help you adjustment by 500% but a great idea and something ill make a version of for my packout

This is brilliant!

Brah! That’s a sick setup! Chee hee 🤙🏼

Gracias!!! Nice job

Super smart!

Genius !!

Nice 👍

I like this! Brilliant. What's thickness of board? Is it 1/2" or 3/4" or something else?

Very nice. Can you adjust the depth of the bit?

I would prefer some system that clamps the router in then having to screw it in everytime.