Good deal

Yes, when I change from delay/reverb to volume, the previous setting stays the same and can’t be changed until I press the button on the mc3 again then move the expression pedal again.

Thanks

I power them both with the 529hc and a daisy chain cable. Mission engineering sells a 2.1 to 2.5 adapter which is needed for the hx stomp. Hopefully, I’ll do a video soon explaining that more in detail.

@@DefconClark thanks!

you can't change presets instantaneously, so there will be a short interruption of the audio. but yes you can change presets on the stomp via midi. i don't know how many midi ccs the mc3 can send at once. but in general, you can assign a midi cc to any block of your preset and then switch blocks on/off. So you need to do more programming on your midi controller, but this is a workaround to get "more snapshots".

Yes, but there is no spillover so there will be a slight audio gap.

Yes, I use the expression pedal to control various parameters on a block or set of blocks. Instead of using the midi code for the expression pedal on the stomp, I use an empty code and use midi learn on the stomp.

For that video, I believe I used a daisy chain from the 529hc

Gearbyceba.com the ones on the mc3 are version 1 toppers that are no longer made. The current ones are magnetic, which will fit the stomp just fine but not the mc3.

It is the CME Widi Master. I have some videos about it on my channel if you want to check them out.

Second this! Would really like to know too

You have to set up either foot switch 4 or 5 to toggle between the two expression pedals, then use the midi command for that foot switch (cc 52 fs4 or cc 53 fs5) to toggle them via midi

There’s a setting for snapshot recall or discard. One allows you to change snapshots and keep the settings that you’ve made by turning off the block, the other allows you to change snapshot and they’ll load the way they were saved last.

I’m sure it can if the device you want to control accepts midi.

Thank you!

Something you can recomend me to start learning about MIDI? It’s has been always hard for me because im not pretty good with computers, i record with portastudio and old stuff

@@ap210482 check out my friends channel. He’s very technical and helpful. kzfaq.info

The jet micro is great for a preprogrammed midi controller. I, however, wanted a bit more controllability, expression port, and bigger footprint.

You’ll need a trs to trs patch cable.

Thank you so much.

If you’re in the US, here’s the link: www.gearbyceba.com/line6-family-usa/hx-touch-enabled-foot-switch-toppers-magnetically-attached-usa If you’re outside the US, here’s the link: www.gearbyceba.com/line6-family-international/hx-touch-enabled-foot-switch-toppers-magnetically-attached-int

@@DefconClark thanks 🙌🙌🙌 (those will not work on the MC3 though right?)

@@MauricioBond23 unfortunately not. The first generation would as they screwed on the button. The current evolution magnetically connect which doesn’t work on the MC3.

I’m sure you can achieve similar results with the midi baby. It would be cool if I could get ahold of one to try out for you.

Nano plus

Unfortunately, I don’t believe that’s possible.

Nope, the midi out of the mc3 goes to the midi in of the stomp and controls it that way.

@@DefconClark Thanks!, Definitely considering buying it.

It’s different for sure