Morse Metal Devil Saw (2 Year Update)!
Рет қаралды 1,854
4 жыл бұрынHere I go over my Morse Metal Devil Saw for a 2 year update and what I think about it so far.
@felixf5211 4 жыл бұрын
Appreciate the honest and detailed review.
@BradsWorkbench 4 жыл бұрын
I traded for a wen 4x6 bandsaw for at home and love it. At work we have the klutch 7x12 and its pretty awesome
@AntonioClaudioMichael 4 жыл бұрын
Great thoughts and information good long term review Tim
@phillipdoubleu5474 4 жыл бұрын
Thanks for the quick compare against the abrasive chop saw, I had been wondering if you would cover it.
@frankcon71 3 жыл бұрын
Hi, very nice video thank you. Can you use a 12 inch saw blade?? Or only the 14 inch?? I see some 12 inch saw blades that run's at 1800 RPM and 1 inch bore, and are cheaper, but Can they work with this machine? Where you buy the press? Thnak you.
@timsworkshop85 3 жыл бұрын
As long as the blade has a 1 inch bore it should work. However, with a smaller blade your capacity to cut larger material goes down. As for the press, I built it myself. I have a couple videos of the finished press on my channel.
@tubtubtub55 3 жыл бұрын
I had first the Milwaukee 6190 (now obsolete). Now I have the Jepson 9345. Both saws are siamese, I would bet the Milwauke was built by Jepson. Anyway two things, both have the speed screw on the vice ( a must) and as all the dry cut saw they trow metal chip everywhere.
@craigchiddo2794 2 жыл бұрын
Is the base cast or stamped
@herbertherbomoore415 2 жыл бұрын
What type of generator can you plug it into?
@timsworkshop85 2 жыл бұрын
What type of generator do you have?
@herbertherbomoore415 2 жыл бұрын
You're 👄 more, and haven't ✂ any metal yet!
@timsworkshop85 2 жыл бұрын
I have a separate video of the saw in action cutting c channel.
Full Steam Designs
Рет қаралды 21 М.
SetrispossBoss
Рет қаралды 791 М.
Truck Drive
Рет қаралды 11 МЛН