Great video for beginners like my self!

how to make opposite key way in shaft Upload this video much needed

Use a micrometer to measure stock diameter, then use micrometer to measure depth of keyseat. Subtract the two and you have depth of key seat. A depth mic will give you a wrong reading because you removed the crown of stock, so your measuring below the point of where you should be, and that number is allusive and hard to get.

Measuring method of key way depth is wrong here. It will not give correct depth reading at the place where it is being measured because height reduction is there at key way edges.

Thank you!

😀 good

4TM aanwezig

Hi, great video! what is the name of that reference book? thanks in advance

Yo trabajo en eso pero a escala grande en pies asta 25 feet

And i just wondered about Morse taper number 12 lol- how fucken big would that be🤭