I bought this charger but i have 19.5v 160watts adapter when i plug it input voltage shows 19.50v and cut off 11v should i increase the cutoff voltage from 11 to 19v??
@sammybaka2 ай бұрын
When using a wall charger i don't think the cutoff setting is important. It's needed when using a 3+s lipo battery as input power to b6neo to protect that supplying lipo.
@vladimirmikhailovich8966 ай бұрын
After the power goes out at the input, is there such a thing that the charging process does NOT automatically resume, the device announces an error, and it is necessary to remove the error and press "start" again?
@sammybaka6 ай бұрын
This hasn't happened to me, but I imagine the charger reboots back into the main menu. I wouldn't expect it to resume charging automatically.
@vladimirmikhailovich8966 ай бұрын
@@sammybaka I bought B6ACneo. If the power is lost and appears again, and the battery is connected, the charger goes into displaying the error logo, which in some cases can be removed with the button and select start again.
@popitn2nd8 ай бұрын
I might just go for this set up and charge my battery individually. Where can i get the cable like this? I can solder the xt60 just like you did.
@sammybaka8 ай бұрын
This is my usual recommendation but it's out of stock currently for the xt-60 version (www.wolframrc.com/product/charger-adapter-cable-for-jst-ph-3p-atomic/279?cp=true&sa=false&sbp=false&q=true). You can get the parallel option and just charge one pack at a time (www.amazon.com/JST-PH2-0-Parallel-Battery-Charging-Tinyhawk/dp/B0CBQHSZBW). I just bought a xt-60 female connector and soldered an existing charging cable I had that came with 4mm banana plugs.
@popitn2nd8 ай бұрын
The link was broken on the second link. Btw, did you make this cable your self. If not where did you purchase it? Because i need one with banana plug. It will perfectly fit my old charger as it is.
@sammybaka8 ай бұрын
The amazon link was basically for the same one on kenonhobby too (www.kenonhobby.com/PN-Racing-XT60-Plug-3xJST-PH-Parallel-Charging-Cable_p_46091.html). For me, I already had the charging cable for my jst-ph battery packs, but I needed to change out the banana connectors to xt-60 as seen in this video. If you want the banana plug ones, use the wolframrc link above and get that.
@gotmesom10 ай бұрын
Does that charger do storage
@sammybaka10 ай бұрын
Yes it does. Configurable amperage and target voltage.
@MegaChickenPunch8 ай бұрын
Can it charge just by balancer port? I have a 3S deans battery pack
@sammybaka8 ай бұрын
I just tested this. It won't charge with just the balance port plugged in.
@MegaChickenPunch8 ай бұрын
@@sammybaka thx bro you just saved me a bad buy for me! 🙏