Shifting into high gear. Transmission Assembly Part 2/2 - 1989 Toyota Restoration Episode 29

Рет қаралды 14,896

3 жыл бұрын

Getting back around to finishing up the transmission. I'll be installing all the shifter parts and sealing up the housing ready for it to be bolted to the bell housing and mated to the engine... whenever that happens. :)
HOW TO SUPPORT ME: The best way to support my channel right is to like, comment, and share! If you want to become part of the community I invite you to Subscribe. You can follow me on Instagram as well. Search for nabelrabel.
Equipment( Updated 2/21/2021):
Main Rig:
Canon EOS R
Canon RF 15-35 F2.8
Rode VideoMic Pro Plus (for shop shop)
Rode Wireless Go (for talkie bits)
Secondary Rig:
Blackmagic Micro Cinema Camera
Metabones .71 Speed booster
Canon EF 10-18mm
Canon EF 24-70mm
Other equipment and software
Screen Capture: OBS
Adobe Premeire
Autodesk Inventor Professional
Autodesk Nastran Simulation

Пікірлер: 9

@monolithmotors3802 3 жыл бұрын

Nice detailed work - I am impressed by your surgically clean work area!

@Obscuremotorsports 3 жыл бұрын

Thanks!

@dunstangoraiye1351 2 жыл бұрын

Nice and clean bro.

@jmy6050 2 ай бұрын

I hope you tested the shift mechanism to make sure the selector rods and forks worked properly, before putting the gear cases together.

@gulamrsulgulamrsul5805 Жыл бұрын

assalam walekum rahmtullah barkathhu so beautiful video very nice video

@TheBoogerbat Жыл бұрын

Just curious as to why not do a manual swap considering that the 3.0 is much more efficient paired with the 5spd?

@cryoine7194 3 жыл бұрын

when someone asks you how a gearbox works, just tell them its witchcraft, witchcraft powers the selection of the gears lol

@pdx1jmh 3 жыл бұрын

How did you learn how to do this?

@Obscuremotorsports 3 жыл бұрын

I've torn apart many gearboxes in my life. Anything from RC car gearboxes when I was a kid, to appliance gearboxes when things broke, to cement truck gearboxes for work. They are all basically the same thing. A few shafts, some bearings, a couple gears and maybe a shift assembly. Most of what I've learned comes from what already exists. I do know how to design a gear mesh to meet specific requirements, but I didn't learn about gearboxes by designing them. I learn to design them by taking others apart. If you're curious I recommend buying an AXIAL AX2 RC crawler 2 speed transmission for $60 and take it apart and put it back together. You'll learn good basic concepts of transmissions from a small expense. From there its all the same thing, just bigger.