Great video man!

Great video I have a new apex controller. Is there a way to set up feed button B for maintenance using the virtual outlets. I would like to have my return pump, MP 10 and skimmer off with the skimmer defer 5 mins. I have no modules yet just using the 832. Keep up the great work

Really helpful stuff! I was wondering how I can use a Virtual Outlet to make one DOS do an automatic 3 gallon water change daily, and set that same DOS to do a 25 gallon water change when I hit feed mode D? is this possible? Thanks for any insight.

Hello I have a question about virtual outlets. I want my mix bin to auto refill and alert when it does so I can mix salt, also cut dos awc change off until reset. When lo is reached it turns on rodi solenoid and turn off dos. When lo sensor is covered changes to fill. When hi is reached changes to filled, cut solenoid off and send alert.I mix salt and hit reset button which turns dos back on and repeat cycle. It would be nice to have the v-reset status on(orange) and auto when reset so you know the bin is running awc V-lo V-hi V-fill V-filled V-reset

On the RO status outlet. Is it possible to write a line that states to turn the outlet back to auto after the water level had decreased? That way you don't have to remember to turn it back to auto.

Hey there, quick question if you don't mind. Trying to set up a heater and a pump to run for 24ish hours in my mixing vats. I know there is a limit of 999 unfortunately so I will likely run that. Anyway I have an adaptive reef toggle box which has 4 momentary switches on it. I have the one switch assigned as AR2. I created a virtual outlet called SaltBin with the following code. Fallback OFF Set OFF If AR2 CLOSED Then ON Defer 999:00 Then OFF Then for example in my pump I have the coding set as If Output SaltBin = ON Then ON However, I press the button and nothing is happening to proc the virtual button. Seeing anything wrong in the code? Any suggestions? Appreciate any help. Also appreciate the videos, they have been a huge help.

Question, how to do use a virtual outlet and a 0-10v equipment, such as a skimmer...(Aquamaxx cones dcq-2)

Is this how u setup schemes for the sky lights

If you can create a virtual outlet, why can’t you delete them