PRE-ORDER YOUR GAMELEAP SUB FOR OVERWATCH 2: ► www.gameleap.com/OVERWATCH2?c=cmpgn_qA7Q5bXbz - GM+ Courses ^ THE FASTEST WAY TO RANK UP ^

Kinda crazy that screen shake is even on by default considering how much it throws off your aim. Such a huge improvement turning it off.

Thank you so much, i couldn't figure out why it was so pixilated and small!!

I disagree with some of your video settings. The dynamic render scaling should be set to a fixed value because your input latency would change leading to inconsistency in a competitive setting. Also, you can have the texture quality set to higher than low because it will help the game look slightly better with little to no performance cost if you have a gpu with a moderate amount of vram. Lastly, the FXAA essentially only blurs the image and isn't worth being on at all at that point because it makes outlines slightly fuzzier. Instead, SMAA low is a far better option. Great video though!

For video section, don't forget to use your native resolution and highest refresh rate. Not just the highest resolution that it goes. Make sure you aren't using any super resolution or scaling settings in your GPU driver. Also navigate to your game executable and disable "Fullscreen optimizations" to ensure that there's no added delay from the DWM/Exclusive switching that Windows implemented. IMO, don't bother with dynamic scale unless you're on a low end PC, much preferable to lower your settings and or reduce the resolution to a static value. IE if you're at 2560x1440p then use 75% to be 1080p if desired. Nvidia Reflex has no effect if you have your game capped to a frame rate that leaves some GPU resources available. (so AMD/Intel users do not need to worry) If you have a high amount of VRAM (4GB+) use high textures with 16x Aniso. Using ultra model quality also tends to be fine. Leave shadows on Low, but everything else can be off. Mouse sensitivity: There is a measurable benefit to mouse responsiveness up to 3200 DPI (as long as your mouse sensor natively supports it) See battlenonsense's Razer 8K delay analysis for an example of such. To use 3200 DPI instead of 800, just use 1/4 of the in game sensitivity suggested.

Thanks bro, helped a lot with the lag fix

thanks my friend straight forward clear concise. gl on games!

this helped my lag, thank you :D

Dude thank u so much I was going on 30 fps and a huge delay from the mouse to the monitor

About V-Sync and AMD Cards If you have an AMD Card and using freesync turn v-sync on (in Game and in Drivers) you will have less input lag and a more smooth experience overall. AMD Cards are kinda odd with v-sync + freesync (also cap fps 3 under your max refresh rate) Without freesync go for highest stable FPS possible

I've been having really bad fps stutters after the game came out. Can't believe changing to fullscreen actually made a difference. Thank you :l I've should've tried that first.

it actually helps me a lot, thank you

this helped me so much! thank you!!!

3:45 is wrong, enabled + boost will take away some frames for very insignificant input lag decrease. just enabled should not have any impact on your frames.

My screen displays the game which looks like 360p or smth when its a 1980x1080 one, what resolution is recomendded or1 how to fix it?

This is a new improvement for me thanks

It was the Reduce Buffering for me. Thanks man!

I've been having issues were my game freezes when I get into team fights I have a 8gb of ram I can play the game the random freezes are annoying any way I can fix this

i have been playing on high settings with 250+ fps and guess what I did not even notice screen shake lol thanks for the vid

I switched from fullscreen to borderless bc of screen tearing, my average pc latency was around 28ms and after this i switched it back and tested it was around 9ms. Fullscreen definitely ftw

thx so much it helped a tun.

tysm helped alot

Any fix for the game freezing it freezes and it just stays there on sound loop, any help, i really like the game but i cant play it like this, i have to restart everytime it does that

Thanks bro my fps went from 30 to 10

i had a few of those settings already tuned like the example. so personally i don't see a big difference. the game does look more smooth tho. thanks for the video!

Hello,can i have some help here,soo when i put the resolution to the highest 240fps it does a black screen can u Pls help me

Omg thanks you so much i was to 30fps and now 60fps

ILYSM THANK YOU

I have a powerful graphics card and i want my game to look nice, but i dont want anything interrupting me like a bright sun or reflections. What settings should i turn to low or off in that sense?

I can play the game normally, but sometimes it completely freezes and kicks me out. It says something about my rendering device has lost connection, application closing (?) I don't know how to fix it, the game is fine tho but in few of them that happens

Important for render scale: Outlines for players are actually thicker the lower you go from 100% which you can not see from this comparison picture as there were no players. Yes it looks hard to play on that picture but really its quite good and you can see enemies quite well. Not only when you have bad PC but also many pros use lower render scale like Asking used 50% even i remember. They do it in effort to keep consistant 400 fps and also thicker outline for some. I have just about constant 240 fps and I need to see a bit sharper long range so i keep 100% render scale as I almost one trick widow.

Thank You Very Much

Borderless works fine if you force V-sync off in the Nvidia Control Panel, tested in a live game and if you do that FPS is uncapped and input lag (according to overwatch shift+n menu) is within .2ms of fullscreen.

Can you help me pls when ever i go in a game i get like 1 fps per 2 second for like 2 min this didnt happen when i first downloaded the game

Thanks I'm using my school laptop and now it's pushing out 20 more frames cheers

Desired FPS isnt showing up for me. Do you have a fix?

We need a controller settings video next because the aiming on console is off in ow2

Tysm

Thanks

actually saved me

Can you go I we how to play Push and the best strategies plz?

Damn i didnt notice i had to set my fps in my resolution settings, I was stuck at 60. This helped alot

If i want to play competitively, should turn all graphic settings to be low? Even If i have decent pc ?

Thank you

tysm

Controller settings next plz

Are these settings good for ps4 as well??

Thx

think you have to zoom in more i couldn't see what's on screen.

Thanks

Controller aim smoothing is bleeding into mouse controls.. Need to set that slider to 0 for most responsive aim

nice video, followed

why my fps stuck in 60 ? even my display selected is 1920x1080 240 and the fps i set to 240 too

Anybody been getting crazy amount of frame drops and freezing moments that they normally wouldn’t get on Overwatch 2 ?

How do I enable hdr support?

Two ads in the video, sounds promising :Kappa: . Anyway thanks for the Tips! Good explanation.

Hello I think i need help idk if it is a glitch but i think so. I play on a xbox series s and I have 120hz but when I play ow2 it works fine in like 2hours and it is dropping to like 70 - 90fps and I play on framerate mode. And when I restart it works fine again and it does the exact same is this a glitch?

I have bad lag spikes when I stand still I get around 200 fps but then I slightly move or someone does something I lag and or get 0-2 fps for like 30 seconds

THX

This is for sure going to get me out of bronze

5:10 me at 1600 dpi and 20 sensitivity Well, i guess I’ve been doing it wrong this whole time.

I can't use full screen cause the game freezes and crashes. If I use full screen then I can't close the game and I have to restart the pc. I don't think it's a performance problem, I have a 1050ti. It's so frustrating

Are yall going to do vod reviews, I want to see if I'm improving in overwatch 2

Bro I can't play it because my laptop is windows 8.1 any chance you can help me?

thanks

Holy hell gameleap is on roll today 👌

i play on Console (xbox serie X), theres something weird i found, i dont know if its only on console or whatever maybe my fault but every level change i did 0-100 I CANT STILL SEE THE RESPAWN ICON!!! i can see the waypoint but not respawn icon!!! im not kidding loll and theres no way in that game to turn it off except 0-100! then why i cant see it!! it could be realy usefull in new map when i need to regroup... above all the push mode!

Apparently there is a bug where controller settings are affecting K&M so would be best to bring Aim Smoothing in Controller Advanced down to 0.

my resouliton is cap to 60 how i fix

Mine is the enemies are glitchy like shaky movement lol

You can’t be serious charging more as much if not more than every streaming service for overwatch tips

Thank you for this video.

None of these setting exist in the video tab. None of them. Is this no longer in overwatch?

nice ty

is anyone else's game crashing randomly? my game always runs 60+ fps but sometimes my game just crashes. my cpu is a lot better than my gpu but it shouldnt make it crash like that if it runs fine

I dont have get half those options for video?

how do I get costume colour settings

turn aim smoothing off on pc. a bug causes it to bleed into m and k

Please tell us about Nintendo switch console?

I have the same settings with over the recommended parts In my pc yet it still can’t run this game at all even though in the beta it could run it on full ultra graphics it’s starting to tick me off and I don’t know what to do

I think that there is something wrong with overwatch on my pc. So my pc specs are: Intel core i-5 10300H, Gtx 1650 and 8 gb of ram. In games like valorant or minecraft I easily get 200 fps constantly but I just downloaded overwatch today and I am literally getting 3-10 fps in the menu/loading screens. Also, whenever I put my game into full screen, it moves the game over to my laptop screen (I have an external monitor set as my main display and laptop as my secondary) So i'm not really sure what to do, if anyone has any ideas please let me know!

Im curious why my ow2 keep freezing while playing

Can I run this on Nvidia GeForce GT 420, AMD Athlon 200GE, and 8GB of ram?

I have this issue only on OW2 my screen goes black when alt tab eveb though i have the same resolution and refresh rate ingame, anyone have the same issue?

Can I not change the fov on series x??? It won't let me

This is the first time I heard about fullscreen 😂 always used borderless.

My game is capped at 60 fps although i have a 144 hz monitor. I have raised the cap to 144 hz it doesn't change anything. Strangely this only applies, if my laptop is plugged in. Has any of u any ideas?

Re do this for all console players!

you never want mouse precision btw that means mouse accelleration

Why don’t I have those setting for video?

running a ryzen 5 5600x gtx 1070 16gb 3200mhz ram 1tb ssd and it runs nice gonna get a rtx 3060 or 3070 if i can on december

Is it true that OW2 has issues with GTX 1050Ti? No lag or stuttering but it just suddenly freezes and you have to relaunch the game making it unplayable.

I was like why does my game look so trash, it has it on 85hz, on my 240hz monitor.

2:48 so im a new player on overwtach 2 since blizzard give the game free to play, so how make it less blurry. The lowwer fps or higher?

Ever since last ow2 update I been at 300 ping. Idk how to fix that. Never had that problem before and this is my first gaming pc. Never had problem with original ow

"highest ur monitor goes on frame rate" bro mine will explode

Buddy, if i could run my game on this highest res i wouldnt be watching this.

Can you do the same for console players

gameleap literally pumping out videos for the noobs now coming to ow

All these people that recommend full screen are you not experiencing overlays and background apps increasing by 4 to 10x the size, then it takes 10 seconds to tab back in…. This just me?