#shorts Does your new laser cutter seem stupidly low on power? Check this setting in Lightburn to improve the performance.
Пікірлер: 12
@jld94442 ай бұрын
You legend. I knew S Value was out, changed it everywhere I could see after a new install of lightburn, but I wasnt cutting anything! Not even mustard. This was indeed set to 255 (why?!?) despite $30 giving back = 1000.000, and other LB signals that all was well. Thank you again, lifesaver!
@NeilB2472 ай бұрын
Glad it helped. I understand your frustration. Enjoy your "New" laser.
@perrythebeast9 ай бұрын
Cheers for this! Wondered why my new 20w laser was barely cutting 3.6mm plywood.. Setting changed and we're all good 👍
@NeilB2479 ай бұрын
Glad it helped. It was infuriating.
@FlankCobra7 ай бұрын
Problem is that it is 1000 and laser setting the value $30 = 1000 too So S value max matches it does't use not even 20% power.
@petrsvetr5271 Жыл бұрын
Thank you man. ❤
@NeilB247 Жыл бұрын
No worries!
@nightwalker35698 ай бұрын
Hi,what is 10 watt laser best cutting settings ? Power speed pass?
@DIYTECHBROS Жыл бұрын
👍
@SAVOROG10 ай бұрын
Nice but does it kill the laser faster?
@NeilB24710 ай бұрын
I have to admit I don't know. I do try not to run at 100% all the time because I think there is a chance it will reduce the life. I make sure to clean the lens regularly too. It is a powerful machine and quite capable when you get it set uphow you want it. If I was to buy one again though, I would save up for a CO2 for clear acrylic.
@tomaszpralat3447 ай бұрын
but which settings are correct orginal , 225 or 1000 and on 225 my laser work corect before or not and I change by mistake from 1000 to 225 thanks for answer