Decided that I wasn't keen on hand tapping too many more holes...
Пікірлер: 10
@bostedtap83995 күн бұрын
YG are excellent machining tools. Nice addition to the shop. Thanks for sharing
@docsofftopic8130Күн бұрын
I’ve been very happy with the taps and will likely look to see what else they make in that department…
@y-notforge89136 күн бұрын
..That looks to be a Good piece of equipment Doc. That's better than eye ballin for vertical...!
@docsofftopic81305 күн бұрын
Yep that was my main reason, tried tapping in the mill too cramped and broke some taps as a result sooo here we are
@jackdawg45796 күн бұрын
So how high did you space the plate above the deck to be sure you wouldnt end up bottoming your tap out on the bench surface? That would be my biggest fear! Also I like the YG taps as well, a mechanical engineer mate put me on to them a few years ago, cheap as chips on ali express.
@docsofftopic81306 күн бұрын
Pair of 1/2” parallels as packing was going to use some 123 blocks but this seemed easier from a fiction pov.
@karennoyce10156 күн бұрын
Great video can I ask where you got the tapping arm from? :)
@docsofftopic81306 күн бұрын
It was via AliExpress, just waited till there was one with shipping that wasn’t more than the arm. Now waiting to hear back on what they will do about the minor shipping damage
@danmooney71926 күн бұрын
How about a link to the tapping arm?
@docsofftopic81306 күн бұрын
I will once I’m satisfied with their response to the shipping damage. Not going to recommend a supplier with poor customer service…