I just completed the rear shackles on my 2008 Nissan Frontier. Here is just a helpful hint. You won't need to use a pry bar if you remove the shocks.
@crisayala1252 Жыл бұрын
Is it hard to put the shocks backs after?
@accobra66269 Жыл бұрын
Straight and clear and to the point. Excellent video for someone like my self that will always give it a try, just need what you delivered.
@valzlan33213 жыл бұрын
had to look twice. I measured and there is a significant height distance at the front. Nice. I have a 2.5 lift. actual is 2" when I checked the manufacture. 2" in the rear which leaves the back still 1" higher than the front.
@Dutchman2070 Жыл бұрын
Best video out there for this project. You have the tools and the experience. There are other videos where they work on this way past dark, ha.
@aalonbullard93203 жыл бұрын
quite simple but i like the detailing of the process. very enjoyable watch
@creative_expressionproductions3 жыл бұрын
i had legitimate fear for my face and your fingers when you were levering that spring!
@carlosdanger46482 жыл бұрын
Ve got the same kit I really need to install it also got UCa’s and cam bolts
@brandongarciabrandongarcia7733Ай бұрын
Nice video thanks
@derekjustice55143 жыл бұрын
Do you have stock size 265/70r16 tires or did you go with 265/75’s? Those wranglers look good
@vashman01 Жыл бұрын
Two years later. Have the UCAs been making contact with the coil buckets? Did you have to change them? I'm looking to do that now.
@TWX11383 жыл бұрын
You may want to look at springs in addition to the spacers. I just built a front-mount receiver that's concealed within the factory bumper for my '15, it's heavy enough t take around a quarter inch off my ride height. When I put the winch on a slide-in mount into the receiver I'm down somewhere between 3/4" and 1" from stock. Still haven't settled on what springs I'm going to go with, or what shocks. If I go sort of OE, R51 Nissan Pathfinders had an optional V8, and the front coils were a little bit longer than the factory V6 coils common to both the Pathfinder and the Frontier. They're a possible contender. I'm also looking at aftermarket springs, but haven't yet evaluated shock travel into the equation. I wouldn't mind gaining around an inch of extra height over the stock ride height pre-changes but I don't want to go too crazy.
@billywill9033 жыл бұрын
Check alldogs they have all kinds of lifts shocks and springs
@mp-ot7fw3 жыл бұрын
what I wonder about with the "In addition to" part...it seems like a spacer is going to compress the spring. If you get stiffer springs on top of the spacer compression, wouldn't the truck feel like you're riding on rocks? Wouldn't be better if you need stiffer springs just to get springs and better shocks and ditch the spacer? Just asking.
@TWX11383 жыл бұрын
@@mp-ot7fw Spacer doesn't compress the spring. The spacer lifts the vehicle up relative to the spacer. The spacer goes above the tophat on the strut.
@mp-ot7fw3 жыл бұрын
@@TWX1138 You are correct, I am wrong. Sorry and good catch.
@dmanch52848 ай бұрын
Any interference issues with the upper control arm and the tower with the spacers. Ive been told not to use lift spacers cause of the interference at full droop.
@valzlan33213 жыл бұрын
I did check the tire clearance. and your tire can be 75. I have 265x70x16 and there is a lot of room all around especially height. However I found out about titan swap. I'm working on that now. there is some added costs but not that much.
@eastcoastbrushworks63272 ай бұрын
No issues with coil-bucket contact? I've read content about how just spacer lifts cause coil-bucket contact due to wheel travel.
@tonyhernan32863 жыл бұрын
I'll have a nisssan frontier 2018 to . And I try to do to many changes like you
@ianmaciver6123 жыл бұрын
Have the kit and a 2012 RWD apprehensive to change the truck- concern is the "coil bucket" contact and detracting from handling: don't want to find out UCAs are al$o needed.
@TheNiuhuskies092 жыл бұрын
Where'd you get that fromt bumper?
@performance8083 жыл бұрын
Nice should of taken off the swaybar end links on both sides and rotated the bar down you would have alot of room to add spacers or put lifted shock and spring
@AshtonDee9 ай бұрын
Great video
@Over_Lando Жыл бұрын
Awesome !! This is a very very helpful video
@woof35983 жыл бұрын
I wonder why they went with shackles instead of blocks in the rear ?
@carlosdanger46482 жыл бұрын
Rough country says that the exhaust can get in the way
@Z-Bart3 жыл бұрын
Looks great. 👍
@blakeborycki55713 жыл бұрын
Why not just remove the hangers and bend the stock one back or just get a new cat back?
@josueblanco5201 Жыл бұрын
Did you buy the truck with the front bumper or did you buy/make it?
@christophernewsom14543 жыл бұрын
What front bumper is that and how much?
@jorgeorozco74673 жыл бұрын
I have a question about do not have to remplace the control Arm because I have a Nissan to but I lifted and make to much noise
@ThrowyaXup10 ай бұрын
What size are those tires?
@fishingwithgrizzly67353 жыл бұрын
Did you run into any coil bucket contact with these spacers?
@MattVerley3 жыл бұрын
Nope. They're clear of the buckets
@cameronedwards12412 жыл бұрын
How’s it held up in the past year
@tomm899 Жыл бұрын
Will this work on the pro4x.- 2012
@terraformingcats8175 Жыл бұрын
Any issues with coil bucket contact?
@omarreyes56693 жыл бұрын
How much should all that cost? To get done at a shop?
@josehuezo35282 жыл бұрын
What is the kit that you used to lift up the nesan frontier.
@thehuntingparadox22913 жыл бұрын
Good vid. I've only seen 2 other videos on this kit. I have mine arriving tomorrow for my 17. Should I have bought the cam bolts? The longer ones? Some people say yes and some say no. Kinda wish I had a place here in middle TN that I could rent a lift stall for half a day...lol.
@armandoarroyoАй бұрын
Did you buy cam bolts? What are those for? Thanks
@thehuntingparadox2291Ай бұрын
@@armandoarroyo I ended up selling the frontier in 2022. I ended up not needing them. The dealer said there was no issue with them stock ones. I would say if you want to buy them just to make sure then go ahead and get them just in case you need them. Every place requires something different. It’s mainly for alignment purposes if I remember correctly. Sometimes with some kits the stock bolts aren’t long enough.
@armandoarroyoАй бұрын
@@thehuntingparadox2291 I’ll get the RG 2.5 lift kit, I’m not buying them. Thanks
@mp-ot7fw3 жыл бұрын
So how does it ride and would you recommend this kit for a daily driver who wants to add trail capability? (Obviously not rock crawling)
@NaritasanStudios3 жыл бұрын
Yes
@thebanjoman19633 жыл бұрын
You sold the sidekick?? Bummer..
@MattVerley3 жыл бұрын
I did; I went an entire year and only took it on one off road trip. I was letting one of my employees use it for work, but it really wasn't ideal for that. Just didn't make sense to keep it if I was too busy to use it. This truck takes its place for work and the occasional overland trip, and I bought a 2nd frontier for my son to drive.
@truck2121213 жыл бұрын
All dogs off-road check their lift kit out
@dillonroberts65902 жыл бұрын
At 10:54 my sway bar on my frontier the bolt behind the one you drilled out rotates with the front. How do you fix this problem to where the boot will come out?
@dillonroberts65902 жыл бұрын
Bolt*
@foxbodystang85873 ай бұрын
How was the ride compared to factory?
@PaulOnMars3 жыл бұрын
Does the kit work on the Desert Runner?
@smonger60182 жыл бұрын
How did you drop your sway bar??
@mariocanales47352 жыл бұрын
Thanks for all the info, by the way can you tell me what kind of bumper that is for my Nissan frontier 2016
@Iann1282 жыл бұрын
He built it from scratch, check out his other videos 🙂
@mariocanales47352 жыл бұрын
@@Iann128 thanks I'll check them out.
@Salixspp Жыл бұрын
Hey Matt, I also use my Frontier for forestry work and need to lift the front up a little - I have airbags in the rear. Do you get any coil bucket contact with the spacers? I ask because you and I are probably driving similar speeds on similar roads. Any help is appreciated. Cheers
@MattVerley Жыл бұрын
I have had no issues with the front spacers, and have around 20,000 miles on gravel roads since I installed them.
@lifeonwheels50802 жыл бұрын
What size tires do you have?
@tommypearson92603 жыл бұрын
Just FYI i cut my exhaust just short of the Axel and made it a downpipe. All to fit my 35 inch spare on the bottom lol kzfaq.info/get/bejne/e8uSldN229TDh4U.html Downpipe Also this is the way it was first cut until i re-cut to adjust kzfaq.info/get/bejne/rL1xe7ab0pq4qqs.html
@mdubbyah33693 жыл бұрын
Hey I just installed the Supreme suspensions 3/2" kit which is very similar to the RC kit. However, the rear shackles didnt give me the full 2 inches in lift (only about a half inch - 1) and appeared to almost instantly cause my leaf springs to start forming a "W" instead of the arch they had before. Now my truck is borderline "squatting" and i cant seem to find any help online as to WHY the rear shackles didnt work as they should. Im considering removing the shackles and reinstalling my OEM shackles to preserve the life of my leafsprings and going the AAL route.
@vashman01 Жыл бұрын
Supreme changed their lift kit and replaced the shackles with blocks that fit between the axle and the leaf springs. Doesn't mess with the springs that way and you get the full 2" out of it.
@AK-ky3ou3 жыл бұрын
What size are the duratracs? 70 or 75?
@tipit00863 жыл бұрын
Just wondering if you need to change the rear shocks for longer ones ?
@Studmn2 жыл бұрын
No!
@db886163 жыл бұрын
Thanks for the video. Did you notice much change in the ride after installing the lift?
@MattVerley3 жыл бұрын
Nope, pretty much the same as stock. Steering wandered a bit until I got it in for an alignment, but once that was done it feels just like stock.
@kylermorgan35852 жыл бұрын
I got the actual leveling kit and I couldn’t get an alignment without changing my camber bolts to adjustable ones
@kevlar92085 ай бұрын
12:40
@NaritasanStudios3 жыл бұрын
Nice video but I'd never go rough country. Way over priced for a couple blocks of aluminum and couple of plates of metal. I paid right around 30 dollars for my no name spacer kit online. My spacers have held up great for the past 8 months. I haven't had to re tighten them or make any other adjustments so far.
@gatorglenn28923 жыл бұрын
Was Cam bolts needed to get the alignment back in spec?
@tommypearson92603 жыл бұрын
Anything after 2012 Shouldn't need those they are already there. Previous models you would have to buy them and put them in yourself no longer!
@AK-ky3ou3 жыл бұрын
@@tommypearson9260 not true, they are only on 05’s. Any that weren’t aligned to spec got them, so maybe 5%.
@Hooijnbvn2 жыл бұрын
Just did the same kit. Purchased adjustable camber bolts. Not needed. Only the toe was out. After alignment, zero issues. 2021 SV 4x4
@richardtalbert6392 жыл бұрын
What's your call sign?
@MattVerley2 жыл бұрын
KE7RKL
@richardtalbert6392 жыл бұрын
@@MattVerley W4IHC
@TheNiuhuskies092 жыл бұрын
@@MattVerley where'd you get that bumper
@MattVerley2 жыл бұрын
@@TheNiuhuskies09 I built it...its in my previous videos