Remember to like, subscribe and share these videos if they tickle your fancy. Pappa needs a brand new camera and lens! (always).
Пікірлер: 17
@brucehayes7251 Жыл бұрын
Its rather sad that the manufacturers are cheaping out on the builds. Watching Lyle and uncle Doug plus the Australian contingent your hopes would be a realisation that they really should change their standards. Thank god there are clever bods such as yourself willing and able to bail us out ,regards
@hheidrick Жыл бұрын
Hey nice ring Dude. LOL! Congratulations on your Wedding
@Jackson-kz7my Жыл бұрын
Great to see this in detail Brad, A lot of what you mentioned lines up with what I've heard of modern reissues, but I guess that's the compromise I bought into! Will definitely swing by again
@dcallan812 Жыл бұрын
Got to love a good J solder joint. As an apprentice we had our work kicked back when making up wire ends if we twisted the wire before terminating. 😡 It alter the cross-sectional area of the wire bla bla bla. It still has the same amount of copper but oooh no. Catch you next time (if big clives not live that is 🤣) nice one 2x👍
@75YBA Жыл бұрын
It’s amazing how many corners get cut on modern amps. Obviously, old amps suffered the same but at least they’re easier to work on. I’ve been so lucky with my amps.
@diangara3298 Жыл бұрын
Nice one mate.
@user-qy9bf7wd1j7 ай бұрын
Save the cute Reverby ! That poor Reverby Life has to be revived for good !
@evj63 Жыл бұрын
Hey Brad, I have a 1991 blackface twin reverb with an almost identical issue except that it's burning the other side of the fuse holder (and eventually blowing the fuse). I suspect there is something going on downstream - maybe a short in one of the power tubes - so the fix you've implemented here would probably not be advisable in my case. Would you agree?
@BradsGuitarGarage Жыл бұрын
You probably just had a slightly higher contact resistance on the other side of the fuse, but it's likely the same issue. I'd suggest getting a tech to check it out if you're not comfortably confident that there's no other problem, though.
@muntor7935 Жыл бұрын
If it's bad to run an amp with no speaker why is it ok to run it with no springs attached even tho' the reverb driver circuit is basically another power amp?
@BradsGuitarGarage Жыл бұрын
Because it's tiny and isn't capable of generating flyback voltages that would cause problems. It's never been an issue for me or any of my fellow techs, but if it bothered you, you could make a dummy load out of an RCA plug and a 5w resistor.
@muntor7935 Жыл бұрын
@@BradsGuitarGarage thanks.
@evj63 Жыл бұрын
Just to play devils advocate here; but doesn’t what you’ve done here leave the (very expensive) PT open to being destroyed in the event of a downstream problem - like the shorting of a tube heater for instance?
@BradsGuitarGarage Жыл бұрын
Like every Fender, Marshall, Vox amp up to the early 90's? Like every Mesa Boogie ever made? Providing a suitable mains fuse is used, it will open in the event of a heater short. If an unsuitable mains fuse is used, in most cases, all bets are off.