Brother, your Garand videos are the best. Thanks for posting them.

Just got my first garand, thank you so much for all your videos!!! They have been very helpful

Thank you. I watched 2 other videos on this today... And yours is the only one that helped me understand it properly.

My introduction to the M1 Garand was by a retired Gunny who coached a group of us noobs in the initial set up. Years later I actually purchased one, and needed to do this set up, but couldn't remember what it was. Oddly enough, NOBODY seemed to have any idea what it was. Thanks for the info.

Thank you so very much. I had no idea how to set up the sights on an M1 Garand. Now that I've seen this video I can set up the sights to 100 yards to align with the proper line on the elevation. I also use an M-10 tool to service M1 Garands. That tool just about fits everything except the front sight screw. Just wish they had incorporated an allen wrench of the proper size into the M-10. Now I should be able to hit center of a target at 100 yards.

Thanks. The rear sight is the only part of the gun I haven’t disassembled.

Thanks 4 run down; very helpful.

Great video. Thanks.

I have a suggestion for a future video: how about a complete examination of, and demonstration of the use of the cleaning kit, with use of the M10 tool, that fits in the butt compartment of an M1 Garand?

Great info! I just picked up a ‘44 Winchester that was refurbed ‘LEAD ‘66” and it appears to have a much later hooded rear aperture - I can purchase an original ‘44 Winchester rear peep - is this a worthy change? Thanks

Just checked and noticed there’s a lot of movement with all of the parts on the rear sight. Do you have a video that goes over how to tighten theses parts?

But why did you do 9 clicks? How do you know how many clicks you need to make for elevation?

Really enjoy your videos. Can you make a video showing how to properly space the Garands Gas Cylinder and Front Handguard?

Great video but I don't understand the nine clicks at the beginning. Why NINE clicks? Why not TEN, or ELEVEN? Just asking cause I got a little confused, shouldn't the original 100 yard setting be good enough for 100 yard? Why change it?

Hello, I have a T26 model and need to adjust my front sight but it's kinda old and the screw is really in there. 1. Is there a certain size or tool screw to get it out with ? 2. Should I let a lube soak on it before trying to get it out?

Sorry stupid question here... my windage index line is all the way over to the right. I can't move it back to center. Any ideas???

Is 9 clicks for center hold or 6oclock hold?

is that a NM front sight?

I don’t understand why the sight is moved 9 back from 100 then back up to 100 again. Can somebody explain?

Take it you went to Norwich?

M1A1??????