Purchased mine this month, only had for a week and loving it
@johnmarshall94153 жыл бұрын
Buying one for sure.
@blade316_3 жыл бұрын
I picked a NOVA Viking this afternoon from Don @ Carbatec in Wakerly, QLD .... can't wait to test it out! :)
@chrisswartzwelder84942 жыл бұрын
I tried to tap 3/8 inch plate steel with the Voyager and it did not like it. So on to thinner plate.
@ovnprojects26402 жыл бұрын
How tall is the bench model?
@richardhansen469Ай бұрын
Nice, this is a through hole, but will it tap a blind hole without bottoming out and causing the machine to emergency stop itself? For example if I pre-drill a 6mm deep hole in stock that is 8mm thick, then tell it to tap threads 5 mm long that would give me 1mm of space before it bottoms out, that seems safe. Basically is it smart enough to detect the bottom of the hole and reverse itself?
@dave_ecclectic7 күн бұрын
It will if you set it up to do that. It doesn't detect anything other than a measurement.
@dmcwoodworx29684 жыл бұрын
This offering is part of a series, which was cut off by the Covid-19 Lockdown.
@zkcreationsllcАй бұрын
How do you change this to tapping mode. I can only get it to reverse for 1-2 seconds.
@dave_ecclectic7 күн бұрын
Press and hold the "on" button then press "off" it will sequence through stop, reverse for 3 seconds, reverse. until quill is returned to top.
@zkcreationsllcКүн бұрын
Thank you! Got it to work.
@totheknee3 ай бұрын
Please tell me there's a 12" version...
@dave_ecclectic7 күн бұрын
Buy the 16" version. cut 4" off the column.
@Mike-Wolfe4 жыл бұрын
I would easily trade 2 pack's of toilet paper for this machine. Coronavirus 2020
@dmcwoodworx29684 жыл бұрын
There is a a potential seller in Australia. Apparently they "over bought", with the intention of making money, until their account was deleted! Now they cannot even get a refund