Just bought the 16,000 grain On the Go softener...should arrive in the next few days. Thanks for the explanation, as it will certainly be helpful in the future!

This definitely helped me. Thanks.

These work great .

Finally got it apart and I was shown by a friend to put vaseline or lubricant on the connections before putting back on portable water softener.

Can I do this for the glacier fresh softener as well?

Recharged my unit last month and strip shows the water is hard already? 🤔 Maybe needed a longer back flush prior to recharge?

how many salt OZ for every Kg resin. i mean what the percentage between ath amount os salt and the amount of resin.??

Should I presume that I should regenerate much more often than the backflush? I understand that it depends on the softness of the water which brings me to another question. How can I tell if my water is no longer soft? Is that just a subjective judgement call?

I am using this in an RV park where I was told I can't just waste water flushing the system, can I just let the inside faucet run and let everything go down the drain into the rv site drain would that damage the rv pipes? If it wouldn't it would save me the worry of getting myself in trouble at the park. I got this off amazon

If I just use my on the go monthly to top off hot tub and clean filters, how often do I need to regenerate and back wash?

Have another question. I have taken coarse water softener salt and blended it. So now its essentially salt powder. Does the salt need to be fine grain? Or is salt turned into a powder ok?

When you regenerate which end do you pump the water through?

Are there any videos on back flushing?

I cannot get the grey top off, it is extremely tight and won’t budge at all. How can I get it off?

Do you have to back flush (the dbl standard) first, Before salt? Do you recommend using "Iron out", during regen, along with salt for very hard water areas?

Can this salt process be done on any DI tank?

What is full stream after flushing? Does that mean wide open on water pressure? My water is so hard in west Texas as a full time RVer. I think this is to small and to much maintenance for my condition.

I can't get the outflow hose disconnected. I used WD40, salt, fought with it, Im getting mad, I live in RV and need water

is there a way to hook this up to a house shower? like in an apartment.

Is using salt pellets for regen okay? Or is the granulated salt the best in this scenario?

Does anyone have problem opening the top cap?

how do you know when to do this process? I just received the standard dual bed

How often do I need to add salt.??

do I have to drain the old salt?

I followed the steps and nothing happened strip still turns red.. I recharged it successfully last time but no luck.. any ideas?

Cant get the cap off at all for the first regeneration. Anyone else here trying to figure out just how to get tue cap off?

What happens if you accidentally (out of stupidity) dump some of the resin out?

Can I use salt chrystals instead of regular table salt?

They dont sell the reginitive resin anymore

CAN YOU PUT TABLETS IN THERE WITH IRON PROTECTION

The top cap is impossible to remove! Can someone help?

I am speaking of the Original RV water filter 16000 grains.

What is the lowest PPM after the regeneration process?

Just followed the steps for regeneration, but for some reason when testing the water coming out, it's actually reading harder than the water that comes straight out of the tap. Any ideas?

Does this apply to DI tanks

Can I use this for my shower head?

Does the water supply then go into the outlet side to flush? Or does the water supply just get reconnected to the "In" side? Im stumped with the term backflushing. Im assuming that means you actually run the water source backwards through the out? Connect water source to out? drain out of the input side? I use this in my shower. I have a wand hose that goes from shower neck into the In side. Another shower hose and wand coming out of the output side. Just confused.

I mis-read the regeneration instructions and took off the cap to drain the unit. Lots of brown stuff came out which I assume was the resin. Now what do I do? It was a LOT of resin! Please advise.

You forgot to mention removing the inlet side connections before turning the unit upsidedown to drain the water.

What if I accidentally poured out the resin?

We have followed the steps, but our regeneration only lasts for about 60 gallons of water. We have the double standard. What is wrong?

Average water use to regenerate? We're offgrid...

GET RID OF THAT BACKGROUND MUSIC! The "music" makes it difficult to HEAR what you are saying.

Just a minute Donald Trum.... errrrr.... Donald Duck, you are telling ME! that the POS Campground Owners out there are going to let ME! dump that much water while playing around with one of these when I had a CG Owner refuse me to clean my windshields because very conveniently outside the CG there was on of those DIY Car Washes?