Onefinity Elite Probing

Рет қаралды 3,259

Mike Bogart

Жыл бұрын

Probing on the Onefinity Elite series.

Пікірлер: 14

@r7j7t7 Жыл бұрын

Still about 6 weeks out for my Onefinity Elite delivery but very much appreciate any info you provide.

@BillyCooter Жыл бұрын

Very hepful. Thanks Mike!

@a91customs Жыл бұрын

Agreed!

@st0mper121 11 ай бұрын

I really wish i would have waited. Still hoping for a upgrade path to the elite...Still love my Onefinity. I want to upgrade mine to the x-50 but im holding off to find out if i can get a upgrade path to that controller.

@johnread7404 Жыл бұрын

If using a precision piece like that to probe, it's important to probe your Z using the tool you will be using.

@mikebogart3841 Жыл бұрын

Yes, if you’re not using a tool setter. I am using a tool setter so I can probe Z with pin and when the bit change is called for it will measure the bit and apply the difference in offsets on Z to make everything work correctly.

@johnread7404 Жыл бұрын

@@mikebogart3841 Of course. I've just ordered a tool setter and have been using your fantastic spindle control cable you sent. I wasn't undermining you just putting it in for those who didn't\don't know.

@8thsinner 7 ай бұрын

Does it actually matter enough that the probe moves during contact or should you hold it against the work piece?

@mikebogart3841 7 ай бұрын

I always hold it in place.

@betobeto7903 8 ай бұрын

Hi I bought a Journeyman Elite and having a probing issue. I am new to this so good chance its an operator error…. Question, I went through the probing process but once cutting out a simple circle its not starting the cut within the probing area at all. Should the probing tell the CNC where the work area will be at or do you think something is wrong with the probing device?

@LaceyGloss 11 ай бұрын

Question: you said the Probe Diameter is the bit diameter.. Do you mean the bit shaft diameter or the blade diameter? All my bits have a 1/4 shaft. So, if I use a 1/4 shaft bit with a 1/8 blade, what do I put in as the probe diameter?

@mikebogart3841 11 ай бұрын

You’d use the cutter diameter as that is what will contact the block.