How to use the Onefinity CNC Zero probe. Including theory, pro tips, and step by step instructions! This video is for beginner to advanced CNC users. Etsy Store Link www.etsy.com/shop/ZamoraWoodW... Instagram / zamorawoodworking
Пікірлер: 12
@ryanpelletier Жыл бұрын
You took the time to actually explain the reasoning and theory behind it. That helped me navigate the probe better.
@ryanpelletier Жыл бұрын
Dude. Thank you. This is the most comprehensive look at the Probe that i have seen. very helpful.
@DebHeadworth6 ай бұрын
Wow! Thank you so much for explaining this so clearly and thoroughly! Your video should be added to Onefinity’s official guide. It’s so good.
@DebHeadworth Жыл бұрын
Thanks so much! Your explanation and demo of the actual distances being measured really helped me understand. I appreciate this.
@tmgerhart Жыл бұрын
Very beneficial for the beginner. Thanks very much.
@paulkirkpatrick9939 Жыл бұрын
Just what I needed.
@ronnorris15042 жыл бұрын
Thanks for another great video. Will be ordering you dust boot asap. Look forward to your next video.
@juanchaidez35695 ай бұрын
Can you orient the piece diagonally? To cut something longer than 32"
@sandybanker32132 жыл бұрын
Thankyou very helpful
@bubba6945 Жыл бұрын
you have to fine tune the tolerances and put that data into the control for best accuracy but they are close be default settings
@vabearhunter401 Жыл бұрын
Enjoy your videos.. I was cutting a strip of wood 12in w x 4in h and I probed XYZ.. when I hit start router started process approx 6in to the left. Would you have any ideas?
@bobd. Жыл бұрын
A complete guide should show zeroing out from both the work surface and the machine bed. I watched the whole video and I don't think you covered that. You talked about it very briefly but did not show it.