Simple clamps to tidy up the ol' Rubbermaid shed. This is the Rubbermaid 7x7 shed sold at Lowes, Home Depot, etc Ender 3 Pro: amzn.to/3OLLxVo Hatchbox PETG: amzn.to/3urlwD5
Пікірлер: 11
@Adam_Clegg6 ай бұрын
Where did you get the hooks to attach the wood to?
@mryates76014 күн бұрын
Can’t find the hooks anywhere. Where did you get them.
@kouervang9654 Жыл бұрын
did those hooks for the wall came with the shed?
@jameshess8334 ай бұрын
I’m interested in knowing how the shed held up after the extra weight of the 2x4 on the wall.
@jacehenderson1322 жыл бұрын
@Print Practical I have a question about your skr 2 upgrade on the E3P video i followed your guide and everything is working except for my endstop switches I just dremmeled down one of the teeth for the connector I was wondering if you also had to switch the wires or do something in the firmware. I'd like to move on from the motherboard install so i can get to the reason why i am installing it so any help would be much appreciated.
@0tink92 жыл бұрын
steal toe crocs?
@legionjames18222 жыл бұрын
if those clamps are pla its going to get too hot in there and they will release.
@PrintPractical2 жыл бұрын
They are printed in PETG. It’s going to be pretty hot over the next week or so (80s/90s), I’ll post an update if they fail.
@legionjames18222 жыл бұрын
@@PrintPractical nice i am intrested to know if they hold to that extreme temp. Its gonna be an oven in there. I tried to print petg on my ender 3 and failed again and again. What did you print that on?
@PrintPractical2 жыл бұрын
This is printed on an Ender 3 Pro with a glass bed and my custom direct drive extruder setup. Hotend temp 240, bed temp 70.
@legionjames18222 жыл бұрын
@@PrintPracticalmy next 3d printer will be a prusa. Sounds like your crushing on your ender tho, very nice