Owner Review & Install // AMP Research BedStep2 on RAM 3500 Dually 75419-01A

No video

Owner Review & Install // AMP Research BedStep2 on RAM 3500 Dually 75419-01A

Рет қаралды 4,914

Күн бұрын

Problem: I've dragged along an inexpensive portable/folding bed step for the last 5 years that rests on my rear tire and it has worked great for the most part, but sometimes I forget to bring it along, especially if I'm not towing. That leaves me in a position wanting a step to reach into the side of the bed on my truck, and so when I heard about the AMP Research BedStep2 specifically designed for the side of trucks, I figured I'd give it a try. I've seen the BedStep2 installed on SRW (single rear wheel) trucks, but I've never seen one on a dually. In today's video I'll give you a full review and the install details for the AMP Research BedStep2 on my 2021 RAM 3500 Dually (8' long bed). I believe this exact part number, 75419-01A, will fit all 2019-2023 RAM 3500 long bed dually trucks, but definitely double check your fit with the manufacturer to confirm as they have many different variants specific for each truck model. Note this video is NOT sponsored by the manufacturer...I spent my hard-earned money on it so these are my own personal and unbiased opinions.
00:00 Intro
01:05 Review
06:54 Install Directions
12:45 BedStep2 Install
20:30 Install Tips
23:16 Would I Buy it Again?
Support the channel with these affiliate links. I greatly appreciate it! As an Amazon Associate I earn from qualifying purchases. Below I've included part numbers for the BedStep2 on the most POPULAR heavy duty trucks. Be sure to read reviews online as some short bed trucks with specific options may not be 100% compatible:
2019-2023 RAM 3500 Dually 8' Bed - 75419-01A (This is my truck, featured in video)
imp.i128439.net/jrgj3P
amzn.to/3KXSDqA
2019-2023 RAM 2500/3500 SRW 6'4" & 8' Bed - 75417-01A (Also Mega Cab)
amzn.to/41p2fQr
2017-2023 Ford F250/F350 All Beds - 75413-01A (It's my understanding this sits behind cab, so may not be ideal for 8' beds getting access over axle)
amzn.to/3UxIVyc
2020-2023 GMC Sierra/Chevy Silverado 2500/3500 All Beds - 75418-01A
amzn.to/3A37r0F
Lookup Your Ford, Chevrolet, GMC, Toyota, or RAM truck in the AMP Research Catalog
amzn.to/3KZAmcD
...or if you're looking for the generic, more affordable folding/portable step featured in my video:
amzn.to/41t3i1O
Full Listing of Products in our Online Store
adventure.rocks/store/
#ramtrucks #ram3500 #truck ‪@ampresearchtv‬
Disclaimer: Whilst every attempt has been made to ensure the accuracy of the information presented in this video, no responsibility is taken for any error, omission, or misstatement. This video is for demonstration purposes only and should only be used as such by any prospective viewer. Reliance on such advice, information, or the content of this video is solely at your own risk, including without limitation any safety guidelines, resources, or precautions related to the setup, install, operation, maintenance, or repair of any equipment or any other information available in or through this video. All content contained in this video is not intended to form part of any guarantee or warranty and are offered on an as is, basis. I assume no responsibility for errors or omissions in the contents of this video. In no event shall I be liable for any special, direct, indirect, consequential, or incidental damages such as injury, death, or any damages whatsoever, whether in an action of contract, negligence or other tort, arising out of or in connection with the use of the information or the contents presented in this video.

Пікірлер: 30

@DavidJohnson-ep1wf 10 ай бұрын

I installed a bed step 2 last week. Got an Amazon return for $125. Thought it would take an hour or two to install. 2 days to get the bed bolt out. I only had a 3/8” drive 18mm socket and could not get leverage on that bolt. After acquiring a 1/2 drive 18mm socket and finding my breaker bar, I finally got that bolt out. I could not find a 17/32” drill bit anywhere locally. I used a 1/2” or 16/32” bit and reamed the hole a little to get the riv nut inserted. Now that it is in, I like it. I do understand why I got it cheap as a return, it was not as easy to install as you made it look! I am glad you walked me through it so I knew it actually could be done!!

@AdventureRocks 10 ай бұрын

Wow, that's a great price. Nice find! I'm really enjoying my step still. I like that it's closer to axle compared to the Ford and Chevy ones that are by cab.

@markb8486 Жыл бұрын

I have the Ram factory step, I use it some but, I find using a fold up aluminum step bench works great. I can position it any where around my Ram dually and use it to make stepping up into and out of the truck bed easy. Also it is nice to have to look in to the engine compartment, if you need something to sit on while airing up tire or cleaning wheels etc. After use I just fold it up and clip it to the bed cleat. Thank you for sharing this video I will have to think about the side step.

@JVan8313 Жыл бұрын

I installed one of these in January in a 2022 F350 long bed. It's great.

@CoachDoctorTaj 4 ай бұрын

Without your video the install would have taken me at least 1 or 2 days. 4 hour slater I got it installed. No WI easily reach my hitch and the bed of my 3500 dually.

@AdventureRocks 4 ай бұрын

Thank you, I hear you. It seemed more abstract with the different mount points. I really like it too. Solves a problem!

@jamesmccormick7162 9 ай бұрын

Great video...I have this step sitting in my garage waiting to install on my '23 dually. I had one on my '17 dually, which I traded in. Of course, the '23 is a different part number. Anyway, I thought the price was crazy...I paid $174 for the same step in 2018.

@AdventureRocks 9 ай бұрын

Thank you. Agreed a bit on pricey side.

@chrisk164 Жыл бұрын

Gotta get this...hate jumping up onto the tire to disconnect My 5th wheel..thanks bud

@caseybalvert3547 Жыл бұрын

I installed this step almost two years ago on my dually which is identical to yours. Identical hitch. My purpose was as yours; to make it easy to operate the hitch controls. I also had the tire step but didn't care for the inconvenience. However, I did find that the reach I had without a fifth wheel hooked up was way more than I had once the trailer was attached. I found I couldn't reach the locking pin on the hitch as I was having to fit myself between the bed rail and the trailer. I even tried left foot on the Amp Step and the right foot on the dual tire and just could not maintain my balance to reach the pin comfortably. I ended up having to go back to the tire step for hitching. In part it depends on where your pinbox is situated relative to the overhang on the fifth wheel. I will be interested to hear how far your reach actually is once you have the trailer hooked up. However, the Amp step is nice for reaching stuff in bed. Even at that price point, after using it for almost two years, I would buy it again. I noted you also had a problem drilling into the bed support rail. That metal is extremely hard and even using a new bit, it was a challenge. As well, I noticed that the fuel filler hose was rubbing so used some split heater hosed over it for protection. Hope you find my comments useful.

@AdventureRocks Жыл бұрын

Great feedback, thank you!

@k-mparker Жыл бұрын

I have the same side step in addition to the factory step on the rear. I’m not a fan of the side step - too far forward and a bit low. We full time in fifth wheel and travel around the country and ended using the wife’s 1 ft and a half collapsable plastic folding step stool. Ended up stealing that and got another one for her inside. Super lightweight and folds up for a small footprint and keep in the bed. Makes life a whole lot easier for hitching and unhitching the 5ver. Hardly ever utilize the side step now. Just my 2 cents. Anxiously awaiting your centramatic video!!! 👍😃🍻

@AdventureRocks Жыл бұрын

Great feedback, thank you!

@darrinhiebert Жыл бұрын

We have a 2020 Chevy HD, and that step in the bed is one of the best things about the bed. It is ironic that 70 years ago we used to have step beds, and then we went away from it. Why did it us 70 years to figure out we needed them again???

@AdventureRocks Жыл бұрын

Agree, Chevy beat everyone to the game on steps. Simple detail, but super useful.

@markratliff7991 Жыл бұрын

I have both the exact same portable wheel step as you and the Amp Research side step on my 2015 F450 dually. The Amp Research I prefer to access my toolbox. However. to access my fifth wheel hitch/latch, I can not reach with the side step. I store my portable wheel step in my bed toolbox. Bottom line, I was disappointed in the Amp Research especially because of the price and double the price for the other side

@AdventureRocks Жыл бұрын

Good points. Where does the AMP mount on your F450 dually? I've started to notice that all the OEM steps molded/cut into the bedside are closer to cab on the new Fords and Chevys. So on long wheel base trucks like yours and mine if step is next to cab it's just a glorified tool box step when in that location. I like how AMP designed it to mount closer to the axle on the RAM longbed version as I can reach my fifth wheel hitch and tool box...it's a nice compromise (@ 04:10 demo).

@EricSallick Жыл бұрын

Do you know if any of the AMP-Research BedStep2 models will fit a 2022 RAM 3500 Limited Dually Megacab? I contacted AMP Research to ask and a customer service rep replied they don't have one for the dually. Not sure if they just didn't make one specifically for the Megacab dually but maybe one of their models would still fit that application.

@AdventureRocks Жыл бұрын

I am not 100% sure either. If any of the step models would fit I'd take a chance on the same one I used on my 8' bed. I would think the bed mounting point and leaf spring mounts are in same position on mega cab with short dually bed. Not sure if you can tell from the install portion of video or not...? Comparing yours? You'll have to let us know as I think one other has asked the same thing so far.

@JTRM3 Жыл бұрын

I got excited for your video until you said it won't fit the mega, that stinks....😪

@AdventureRocks Жыл бұрын

Some sites are showing the part number 75417-01A is compatible with Mega Cab and 6'4" bed...but oddly the official manuacturer site does not list it compatible on a 3500 dually. So might have to research on that one further? If you have a SRW mega cab pretty sure this will work, but double check me: 75417-01A amzn.to/41p2fQr

@JTRM3 Жыл бұрын

I have the dually too.

@AdventureRocks Жыл бұрын

@@JTRM3 It's possible same one I installed might work on your mega cab dually...just not 100% sure. If your leaf spring hangers and bed frame mount looks like mine I'd say more likely. But, it's possible RAM used some different dimensions on the mega cab dually.

@brents1643 Жыл бұрын

I can't find 1 for my 23 Dodge duelly

@caseybalvert3547 Жыл бұрын

Should be the same as a 21 as long as it is a long bed.

@AdventureRocks Жыл бұрын

Yes, think AMP Research hasn't updated the year, but pretty sure 23 is same as far as frame goes since it is a carry-over. Definitely check out install portion and see if your 23 looks same, but I'd say good chance you should be fine on the fit.

@brents1643 Жыл бұрын

$300. Um no

@AdventureRocks Жыл бұрын

I hear you, I was reluctant initially too with the price point.

@brents1643 Жыл бұрын

I have the short bed so I don't know if it will work?

@AdventureRocks Жыл бұрын

@@brents1643 If it is SRW I believe it is part 75417-01A...but definitely check reviews as I recall some trim levels & combinations seemed to have fit issues: amzn.to/41p2fQr