Hi Steve. If it’s 7 blinks yes. Check gor shorts on those fets. If it’s not the mosfets on the y sus it could be a buffer board.
@walker55able3 жыл бұрын
Great work thank you.
@PeterOZ615 ай бұрын
mine has the 11 flash fault, dud fan. Tested it with 12v, nil op, put one of the others on that harness and it works, ordered one from china on ebay $20 and waiting for it to rock up. Hopefully that sorts the problem. Interestingly resitence testing the dud fan shows it is not that different to a good one and it spins freely. Would be nice to know what fails in them.
@laurencelagden3 жыл бұрын
Great video Allen. I have a txp42gt30b which went click and turned off, 7 red flashes. My Y sus board is all in one with the buffer board. I had a very loose screw at the top on the set. Also no continuity across one of the power boards fuses. Did you do a video for the 42”? Do you think I may have to change both boards? £200 if I do which I dont want to waste if it doesnt fix it.
@wisher21uk4 жыл бұрын
Nice work good fix
@stevenguyen82623 жыл бұрын
Hi Allen, Would a similar fix be applied to the VT50? Specifically the 65" Panasonic Plasma?
@farazdelijani3 жыл бұрын
good job ....
@EastAngliaUK2 жыл бұрын
I have the 50-inch v20 3d one it's a nice TV.
@express496 Жыл бұрын
Hi i managed to fix my tv but used the original bolts. After a clean and back panel alignment (sound vibrations) i checked the screws and some of them actually moved a little after tightening them again. Do you know the screw size of these boards so i can order new ones with springs and washers to make this not fail again in the near future? They seem like M3
@cybhfal68163 жыл бұрын
Hi, As a TV repair specialist, where do you buy your igbt for Panasonic plasmas (30f131, ....) which are now obsoleted since a Long time and no more in stock at reliable providers (mouser, digikey, rs, ...). eBay and Ali express are mostly fakes and i don't know which seller to trust ! ... Coul'd you share an advice ?
@Vinodranganathan3 жыл бұрын
Hi Allen. I have the 7 blink code on my plasma 42 incher. Model TH-P42S10D. It however works for 5 minutes or so and then goes into a 7 blink standby. What should I do? I am handy with a screwdriver and other basic stuff. Please advice. Thanks.
@allenfleckney59693 жыл бұрын
Check all screws in all boards are tight. You may get lucky
@Vinodranganathan3 жыл бұрын
@@allenfleckney5969 checked all the screws after opening the tv. Cleaned the power supply board, and all boards in general. Reassembled and still the same problem crops up after 5 minutes or so. Next what could I do?
@allenfleckney59693 жыл бұрын
If the screws are tight and there are no shorts on the Y sus. Then it’s usually the main board.
@Vinodranganathan3 жыл бұрын
@@allenfleckney5969 since I only cleaned it and did no checking with a voltage meter, what should I do next? Anything else? Or is it a trip to the tech? Where are you based? Thanks.
@allenfleckney59693 жыл бұрын
Hi Laurence. Shouldn’t be £200 ? Yes your fets on the board would have blown. Plus the IC’s. Also 2 transistors and a fuse on the power supply short out sometimes. Plenty of repair agents on eBay that will sort this for you.
@TopXenn3 жыл бұрын
I must try fixing mine
@msousa41835 ай бұрын
After changing the components the screen has two horizontal lines
@JohnSmith-wj4sh3 жыл бұрын
Nice video. I have the Panasonic TC-P50GT30. Had the 7 blinking lights. Board TNPA5335 was repaired 9/24/2020. Received board 9/29/2020 and installed it. Now the TV is blinking 8 lights. Any advice?
@allenfleckney59693 жыл бұрын
Hi John 8 blinks is usually the X- Z or as panasonic call it the SS board. It’s the right hand side one.
@JohnSmith-wj4sh3 жыл бұрын
@@allenfleckney5969 that's the TNPA 5331 on my tv. Will remove it and get it repaired or replaced. Thanks.
@allenfleckney59693 жыл бұрын
Yes the SS board. Make sure you match the 2 corresponding letters . Maybe AG etc.
@JohnSmith-wj4sh3 жыл бұрын
@@allenfleckney5969I noticed your TV looks the same as mine. But, I noticed you have 4 fans and on the back cover it says UK / Ireland model.
@JohnSmith-wj4sh3 жыл бұрын
@@allenfleckney5969 Also, I have 2 fans and they didn't turn on.
@angelf.lamponsierra43783 жыл бұрын
Ahora tiene el mismo plasma 50" tv. 6 blink
@eridionkiorai9 ай бұрын
Ok wil try to fix my tv because no one can match the plasma picture quality
@felixnunoo61022 жыл бұрын
I could morning how can I get in touch of you
@irwaniswadi Жыл бұрын
Jadi 7 blink apa yang rusak sir? Dan apa saja yang di ganti? Thanks atas video nya...
@angelf.lamponsierra43783 жыл бұрын
Panasoni plasma 50" 6 blinkin
@felixnunoo61022 жыл бұрын
I want to Lane more from me and I want you to be mine teacher on the Panasonic TV set
@Aniketgupta_2k3 жыл бұрын
Foks for camera parts chenge
@angelf.lamponsierra43783 жыл бұрын
Tengo plasma 50" tiene 10 blinki
@allenfleckney59693 жыл бұрын
10 blinks usually power board
@rigi39213 жыл бұрын
Hello, How can I contact you by message or e-mail ? Regards
@reikydrodriguez72832 жыл бұрын
Hello friend I have a problem so you can help me Hello friend I have a problem so you can help me