These guys need a Milwaukee rivet gun. Iv had mine for 5 years as a stainless steel fabricator and never had any issue with 3/16 stainless rivets

I just notice under the sheet. There's downlights, how do you run cabling for those downlights? Look like the foam sandwiched between the sheets.

Is this the same process if it’s freestanding? Would both ends be cut back? Thanks

You think they would put wood stringers on the inside so you can get a place to put a screw into.

How would you install Downlights in this ? Would you have to do it simultaneously with erecting the awning ?

do you have to cut the sheet before bending the ends?

how much this roof will cost for 20 feet long and 12 feet pergola? Roof only with all installations?

How long does it take for polystyrene to decompose. I've used this twice. Also look in the video at the polystyrene blowing all over the joint. How do you get away with the polution. Both times I've used it what a mess. It looks like it has snowed. And why don't you cut the gutter part off in the factory. It's it because of laziness or money. I will never ever use this product again. Polluters of the 21st century. Disgusting. Shamefull.

This is definatley not clear enough to actually do this job. Very poor effort by Stratco.