PHILIPS STEAM IRON GC9630 PUMP PROBLEM, WHY AND HOW TO SOLVE

Рет қаралды 3,201

9 ай бұрын

Other than solenoid valve failures, one of the common problems with GC9630 is pump failures to pump water from the reservoir tank to the boiler. My first video about this steam iron was focused on solenoid valve replacement. You can catch that from this link:
• Replace Solenoid Valve...
In this second video, I will show you the ''main common culprit' that causes the pumping failures.
The new parts you can find from the link below:
shopee.com.my/...

Пікірлер: 8

@gerentirock Ай бұрын

Tuan,sy punya steam iron blinking kat power button, kenapa jd mcm tu,ape solution yg harus dibuat?

@ajjemi84 2 ай бұрын

Tuan, saya nak tanya, my Philips steam generator iron PSG7050 ada masalah apabila nak dihidupkan. Setiap kali kalau nak pakai iron, apabila saya tekan button ON, selepas flashing light bewarna biru 2 3 kali, iron akan betukar color flashing dari biru ke alternate warna putih dan oren pada buton ON, DECALC dan LOW WATER INDICATOR. Saya kena off lepas tu ON balik sampai 2 3 kali baru boleh guna iron. Adakan masalah ini disebabkan oleh pump jugak?

@petrusgoel 9 ай бұрын

6:30 Explain symptoms of pump failures 13:50 shows the pump internal that consists of a plunger, spring, and others 15:30 process of comparing new pump and old pump 18:40 difference between a faulty and a good valve (rubber valve that missing from the old pump). 24:10 reassemble the new pump and fix it inside the unit. 25:52 Testing

@homeopathywanitadankanak-k3416 8 ай бұрын

21:26 part ni bukan getah tp hard plastic. Over use it will get brittle n shattered into pieces. Jd mcm pasir

@petrusgoel 8 ай бұрын

terima kasih clarification. Saya sebut 'getah' sehaja sebab saya pun tak tahu apa binaan dia...yup its hard plastic. Sayang ia tidak ada dijual tapi perlu menukar se unit pam.

@AzreenJafaar 9 ай бұрын

Berapa kerap nak buat penyelenggaraan steam iron?

@petrusgoel 9 ай бұрын

Terima kasih sir tanya. Dua common problem di sini iaitu 1. Masalah solenoid 2. Masalah pam Kedua dua berkaitan dengan ‘worn out’ PVC or rubber based parts. Jadi untuk mengelak ini berlaku pastikan air yang dimasukkan dalam tangki tiada elemen ‘pasir’ dan pastikan tangki tidak kosong. Kalau tangki kosong, pam akan hidup dan panas….cepat rosak. Maybe sebulan sekali drainkan boiler supaya kapur dari air dalam boiler boleh dibuang/flush out. Pam punya getah injap yang kecil itu kira memang akan rosak bila sampai masanya. Sama juga getah solenoid valve.

@AzreenJafaar 9 ай бұрын

tqvm Sir Idola @@petrusgoel