Decided to paint the rear bumper on my lifted Silverado and de badge it to change the rear appearance of it. #liftedmario#plastidip
Пікірлер: 47
@jeffhenderson9343 жыл бұрын
That looks great Mario! Just watching your arm/hand movements spraying in like watching a machine! I’ve got a black 2016 GMC Sierra, want to blackout the bumpers, grille and emblems. Think I’ll start out small a do the emblems first. Thanks for such a great and informative video! You’re a good man!
@etgmaniacc9904 жыл бұрын
My brother mario keep up the content carnal its your boy nano 🔥
@Pureluxe_brand2 жыл бұрын
Adhesive removal quick and easy for that glue 💯 great video
@jamesroberts42333 жыл бұрын
Looks real good bro
@MrWayneploof3 жыл бұрын
looks great
@reggiesmith54582 жыл бұрын
Amazing, looks damn good fam!
@lifted_mario80712 жыл бұрын
Thanks.
@TrashPanda_17764 жыл бұрын
Looks good to me. About to do the grill and bumpers on my 2017 F250. Too much chrome for me. Helpful tip... use tire shine on your plastic trim pieces (bed rails, bumper, front spoiler, ect...) it makes them shine like new again. I always do that after I clean my truck.
@lifted_mario80714 жыл бұрын
Thanks for the advice 👍
@TrashPanda_17764 жыл бұрын
No problem!
@ericball91802 жыл бұрын
I think if you spray a cpl coats of clear high temp engine enamel on it will keep the heat from peeling it.
@_Schwartz3 жыл бұрын
Looks good. Next time try using fishing line to remove the badges👍
@osvaldoramirez99883 жыл бұрын
Looks good man,did you smoke out your taillights or where did you get them from?
@lifted_mario80713 жыл бұрын
There tail light covers and I bough them at amazon.
@david_97lopez254 жыл бұрын
🤙🤙
@streetdomain33423 жыл бұрын
How many cans of each did it take?? I’m doing the same to my truck
@lifted_mario80713 жыл бұрын
I bought two of each but only used 1 and half of the other and only used 1 clear.
@Rev.DavidJTowns4 жыл бұрын
great job! how did it hold up?
@lifted_mario80714 жыл бұрын
It starting to peel on the passenger side by where the exhaust is.
@vidalacosta4983 жыл бұрын
How long did the plasti last.. is it still on there? I have the same truck
@lifted_mario80713 жыл бұрын
It's still in there driver side its starting to peel a little.
@american_chevy6164 жыл бұрын
Sprayed right over your sensors?
@lifted_mario80714 жыл бұрын
Yes.
@bassnbuck134 жыл бұрын
Did the sensors still work?
@lifted_mario80714 жыл бұрын
Yes sensors still work perfectly.
@moraordonez39204 жыл бұрын
ok...that was my question. Thank you
@urairbornepapi27022 жыл бұрын
Great Vid! Get some ceramic coating for the rear bumper plastic molding
@kratos73182 жыл бұрын
You should have done 5-6 coats bro. But nonetheless it looks great!! Great video
@oddbeaner71134 жыл бұрын
Bro I seen yo blacked out truck and I just had to subscribe
@lifted_mario80714 жыл бұрын
Thanks.
@thomasewing52834 жыл бұрын
Has it started peeling off yet
@lifted_mario80714 жыл бұрын
It actually has on the passenger side where the exhaust is.
@actseanjackson74282 жыл бұрын
Not bad did you send it first
@lifted_mario80712 жыл бұрын
I actually didn't sand it I just cleaned it with thinner.
@actseanjackson74282 жыл бұрын
@@lifted_mario8071 k nice job
@lifted_mario80712 жыл бұрын
Thanks
@actseanjackson74282 жыл бұрын
@@lifted_mario8071 yw
@jdegeorge0212894 жыл бұрын
Bumper's clean bro try 2+2 next time
@lifted_mario80714 жыл бұрын
Thanks
@kamotekamote30023 жыл бұрын
It's gonna peal off after a while
@512freeagent3 жыл бұрын
Get a Magic Wheel next time. Thank me later
@Garycruz853 жыл бұрын
No cuema cuhhhh
@shaunbain33053 жыл бұрын
You must have plenty of money! Doing that to a 80,000 dollar truck. Got more money you got sense!!!!!