Great video, thank you again for sharing 👍🏻

2nd time watching this video. This bowl is crazy good!

At the start of the video I thought - this won't end well, at the end of the video I was thinking - that looks brilliant I must try that! Well done, you are a master.

beautiful. I love the variation of colors in the bands. ❤

Thank you for sharing!

Thanks for sharing. That turned out great. Full View and Like 👍

Very nice.

Pretty bowl. I did a plywood bowl many years ago. This one looks much nicer than mine. Well done.

Waste not. Yay, please keep using scraps. If everyone would just realize that almost nothing needs to go to the garbage dump. I have been watching your videos since you started, and I really love your channel. Please continue to make great, simple videos. Cheers, from Tacoma Washington USA 😎

Very interesting

What a great outcome! It looks like an old fashioned ceramic bowl finished in brown and tan glazes. Wonderful!

Great plywood bowl! I notice on your RM Woodturning medallion you put into the center of the back side Carlisle, UK. My family is from there, Udale and Wigton. I need to make a trip across the pond and do some family research.

Plywood bowls are very cool in my opinion. I always enjoy all the lines and character of plywood bowls.

Beautiful outcome. I just want to mention one thing, the general consensus out there is that carbide tools need to be used horizontal on the trest and presented as strictly a scraper, that is a fallacy beyond all belief. Drop your handle and tilt the tool out of 45 and cut on the inside or the supported side of the Carbide tip and you can cut much like a bowl gouge if you use the principle of 45° angle presented to the wood much like you would with a hand plane. You will be presenting the tool in a manner that will slice the wood versus scrape the wood and leave a terrible finish right off the blade. It’s amazing how nice of a cut you can get if you present that tool in the proper manner. It works great with the square and round tip, meaning the square with the radius corners, not so much with the absolutely square tip, it can be done, but you gotta be very careful with that because if you get the unsupported side of the tip into the wood, it’s instant catch, although that is the same with any other tool that you’re using. Watch Glenn Teagle. He is the only person I know that is teaching that technique on the Internet. I have been doing it for years especially on things with a lot of varied grain and end grain or when turning wood, air, wood, air etc. it is so much easier and efficient and fun to turn using a slicing cut. I use my conventional couches a lot, but under some circumstances the carbide cutter used at an angle like that is the most efficient tool you can use in my opinion. And I just turned the tip maybe once every 10 days and I don’t have to sharpen anything for a month, or I just replace the tip with a different one and sharpen the old one

Always amazed how you take scrape wood and make something useful and beautiful from it!

Should have been tool rest and tilt the tool tip at a 45 degree angle

Beautiful. Where do you get your logo insert from?

Nice job just found your channel about to watch though whole load videos get some tips and advice. Am just getting started in wood turning myself. Any advice would be appreciated. I believe i seen carbide tools can i ASk what brand u use?? I bought cheap set carbide not sure if there up to scratch though 👍🏴󠁧󠁢󠁳󠁣󠁴󠁿 Ps am about 40 mins over the border from u in Dumfries

How long will the glue hold the layers stick together?

Fantastic, it's looks very old and rustic. Well done 👍🏻