Polairs rzr 1000 2015 no starter engagement, flywheel sprag clutch

Рет қаралды 31,286

9/Iron

6 жыл бұрын

Flywheel socket for sprag clutch replacement. Starter works but no engagement

Пікірлер: 15

@buildandsow Жыл бұрын

Thanks friend I believe you just helped me understand my problem 👍💥

@carlolding7699 2 жыл бұрын

Thanks! I have the same problem with my Ranger. This really helped!

@guccifluffyakagangstafluff4902 2 жыл бұрын

Service manual has a simple way to test the stator. At the plug coming off the stator Y1, Y2, Y3 should all measure 0.07 - 0.13 ohms when you measure across Y1-Y2, Y1-Y3, Y2-Y3... If any significant variations one leg may be weak or failed.... Or you can test each leg to ground and their should be an Open Line (OL) on multimeter....

@anthonyperez26 Жыл бұрын

I know the feeling with the starter now imagine a starter on a ski 😅

@MPDano 6 жыл бұрын

Did you get your sprag bearing yet? I'll have to do the same job. Ordering my Sprag today as well as a new stator cover gasket.

@9iron642 6 жыл бұрын

Yes . Installed works great. Put about 1000 miles on it and no problems. Good luck

@MPDano 6 жыл бұрын

Great, mines on order. The "bolt" that holds the stator flywheel is "Counter clock" to loosen, correct?

@township.heartland8593 2 жыл бұрын

Hello, someone referred me to this video. We was riding in our 2016, 1000 s. Driving very slow and out of nowhere a strange noise and just shut down and lost power. First thought it was something electrical, switched the fuses around (sometimes that happened) reset the battery terminals and then got power but no start and no engagement, clutch seems to be locked up, wondering if it could be this? I’m very uneducated any help would be great!

@9iron642 2 жыл бұрын

I would say by your text. Does the starter spin? (Make any kind of noise )when you turn the key ? Can you turn the engine over by hand ? Pull the clutch cover off and try and turn the clutch. To see if the motor is free or locked up . Message my back .

@whatsupdocchemdog5994 Жыл бұрын

It's a one way starter cutch bearing that goes bad. Mine just went out. There should be recalls on this but nope Polaris makes us pay for their stupid.

@hap9915 9 ай бұрын

Hello. I have a 2016 XP 900. How can you tell if it's a clutch bearing or sprag clutch.. everything I read said it's the bearing, but now I see this video so I'm confused.

@whatsupdocchemdog5994 9 ай бұрын

@@hap9915 Clutch bearing will have a bearing on the inside ring that can be popped out. 2016 XP 900 most likely a clutch bearing. Do you have the front and rear seater with 4 wheel drive?

@whatsupdocchemdog5994 9 ай бұрын

@@hap9915 BTW it was a ONE WAY clutch bearing on mine.

@hap9915 9 ай бұрын

@@whatsupdocchemdog5994 Thank you. 2 Seater 4x4. Ordered the part (1 way bearing) and puller. Thank you

@WvMnts 6 ай бұрын

I have a 2014 xp1000 it ran/started fine. It has set about a month we went to go riding and starter just spins now.