Thanks buddy... This is exactly my issue...Replaced the starter and was still pinning w/out cranking the motor.
@billpendley25612 ай бұрын
Thanks for your video. I was in the middle of changing my Bendix and when it would not come past the flywheel I started searching for videos. I found yours and one other very helpful. The other one mention taking the Bendix apart by removing the retaining ring. I found removing the retaining ring to be next to impossible while it's still in place. As a last ditch effort I twitched it to the left and it fell out into my hand WITHOUT removing the flywheel. (the starter has to be removed to allow room to make the swing)
@ajsemtb11 ай бұрын
Thank you for this video!! Mine has been like this for 3 years and I couldn't find any good tutorials on it and the forums were not helpful! Had the part for a year. Now I'm going to do it!
@clintlarue5209 ай бұрын
Best video I have found on fixing the exact starting problem I have 👍 Thanx!
@codybyrd85603 ай бұрын
Man that looks like hell to fix a starter issue
@atvrepairsandmore24823 ай бұрын
It looks bad but it actually isn’t bad. Could be worse
@derektoney1663 Жыл бұрын
That was one of the most informative and well recorded step by step instructional video I’ve seen for mechanical projects! I am changing mine tommorrow! However, did you know it was the starter clutch because the alternator obviously had the ability to crank? Asking cause I’m teaching myself by watching videos lol
@nicarry7311 ай бұрын
All good until you didn't Grease it. Not sure what you were thinking. Definitely needs Grease. Everything else is good
@atvrepairsandmore248211 ай бұрын
I don’t put grease on the flywheel or gears in there because I’ve never seen any of them have grease from the factory. Plus I don’t want the grease to fling around in there in the rare case it would mess up the pickup coil. You can put grease on yours I just don’t think it’s all that necessary