Polaris need a video of install power angle and the wiring for Polaris pro plow system

Very clear instructions! Thank you!

Thanks for the excellent video and explanation! I couldn't have done this without it :) During installation, I faced a minor problem, as the front hooks on the plow mount were just a couple of millimeters too narrow to fit onto the hooks (as shown from 4:12 in the video). The hooks were bent very slightly inwards, so I had to bend them just a very small amount (about 2 mm each) in order to be able to get the hooks into place onto the nods on the vehicle frame. Might be helpful to know if any other face the same difficulty when installing the plow :)

I use this blade on my RZR by far sturdiest on the market.

Great video. Lot easier following this than the instructions that came with the plow. They were no help at all. Just confusing.

What plow blade is that size? And part number please and thanks...no grease?!

Will it work with a 300 sportman

It would be cool if Polaris actually did a plowing video showing tips and tricks, just before winter I bought a 2007 Polaris Sportsman X2 that came with a factory 60inch plow and it was quite obvious that the previous owner had no plowing experience. After I adjusted the shoes and springs properly I quickly got the hang of using it and my little 500 can handle a surprising amount of snow.

Hello - can you tell me the length of the ATV with the plow on?

Plow shoes are installed wrong in the video. Cotter pin goes through the side holes to lock the shoes at the heigth set to. Best plus design out there in my opinion though. Been using mine for years

Can this be attached to a 2000 sportsman 500 also?

Why a short and long pin? What is the long pin for? Left side always short on the right as toy face the front of the unit . . . What’s the difference?

On this frame there is a sticker that states the red handle is in the upper position to lock the frame on. The instruction in this video is backward. Just saying!

That’s a lot of clevis