Pond & Trash Pump Irrigation System! (Part 1)

Рет қаралды 35,417

2 жыл бұрын

Do you have a garden or trees that need water but don't have a well or irrigation system? This could be an option for you! This will work with any standard rotors, sprays, drip, or just make a faucet!

Пікірлер: 21

@abrahamtholley5365 5 ай бұрын

Thanks for your videos, I will like to see a video of assembling the irrigation pipes for all pumps

@BonsaiLex 6 ай бұрын

Just got this pump, and answered a lot of my questions. Thanks , great video.

@elicalahan8796 6 ай бұрын

Was looking at water pumps but that drag line is 🔥

@bagermaster-club Ай бұрын

Did you know that a lake can be deepened using a motor pump? You can assemble a mini dredger from two motor pumps. One motor pump for dirt and a third motor pump for hydraulic loosening. Bottom sediments are pumped out using a Bagermaster suction nozzle. You can pump up to 12 cubic meters of sand per hour. And up to 6 meters deep

@erikruiz5004 3 ай бұрын

i do agriculture this way , have one hooked up to a drip system and another one with wobblers (sprinklers)

@freeconomytoday6923 Жыл бұрын

Amazing, we'll be using this for our allotment! 💚

@Mother-earth500 Жыл бұрын

great idea bro

@number1050 Жыл бұрын

Thx for doing. Need same for my fla property to irrigate bermuda lawn.

@jamesanthonyclemons8031 7 ай бұрын

Very cool

@veezienhamoruhwande99 2 ай бұрын

Amazing, thanx

@DennisFahlstrom 22 күн бұрын

Did you consider using ram pumps instead? Not sure how long you’ll be running that small engine every week or if gas expense is even a consideration. Using 2 or 3 ram pumps through some drip irrigation would give your new trees all the moisture they need 24/7 if necessary for free. No gas or solar or electric needed.

@jason27swg Жыл бұрын

Nate any update on this set up ?

@lukejones1244 Жыл бұрын

Can you use rigid metal pipes with this type of pump?

@fulldrawoutdoors4992 10 ай бұрын

Part 2?

@kylearaiza8808 Жыл бұрын

Nice set up. I just got some pumps today. 5 of these exact ones and one of the 3” larger 301cc full trash pumps that puts out about 390gpm. Question for you. How much are you lifting total? Ans have you measured GPM or PSI on the other end? How hard was it to prime the first time? And any issues with PVC? Was PVC more cost effective over hose? Planning to use this to irrigate my land pulling from the river below grade about 50ft down.

@ashtonbeattie8902 Жыл бұрын

The pressure is entirely dependent on the flow rate. If your flow is 390gpm, you're only going to have a couple psi. If your flow is 20gpm, you're going to have about 40psi. It's a continuous curve. Trash pumps are all about moving a large volume of water, they don't have a huge amount of pressure. Pressure is enough to run most sprinklers at 30psi as long as you're alright with less than 50gpm.

@NatesPlaceMI Жыл бұрын

I have since replaced this pump with a similar 2" pump with 85 feet of lift. I used 2" PVC over the hose and put in a check valve so it stays primed. Using PVC you just have to remember to pull it when it gets below freezing and blow out all the lines!

@metroplexchl Жыл бұрын

If an acre is roughly the size of a football field, that pond likes like it's 1/2-3/4 acre maybe? Or am I missing it with the camera angle? Just curious because I'm looking at te same kind of set up and am trying to judge volume.

@NatesPlaceMI Жыл бұрын

Yes it's about 100x350

@codyr.allison-mylife-mymon6513 11 ай бұрын

Curious what you are burning a day on fuel? Fuel per hours?