Does your new pop-top tent fit a little loose (or too tight)?
This replacement bracket kit makes it possible to adjust the final height of your pop-top to achieve optimal pop-top tent tension. This clever kit replaces your original upper lifting mechanism (“H-bar”) pivot brackets with a custom made, GoWesty slotted version. This will allow you to fine-tune the adjustment of the height of the pop-top, either a little higher up (to tighten a floppy tent) or a little bit down (to loosen a too-tight tent).
Timecodes
0:00 - Intro
0:17 - Upper Bracket Removal
0:25 - Lower Retainer Removal
0:41 - H-Bar Removal
1:05 - Removal of Upper Brackets
1:11 - Drill out to 3/8"
1:29 - Installing New Brackets
1:44 - Putting H-Bar back into Vehicle
1:50 - Installing New Retainer w/ Clamp
2:14 - Re-attaching New Brackets to Roof
2:30 - Pop-top Height Adjustment