Porsche Boxster 2.7L engine swap - Pt 3 of 3 Intake install. Wiring harness and connectors
Рет қаралды 124
Жыл бұрынPart 3 of 3 I install the remainder of the wiring harness and relocate some items to fit the install.
@Cat11125122013 9 ай бұрын
Hi, I'm writing from Italy, like you, I have a 2.5 with a 2.7 engine, bought like this. When cold the car doesn't want to start and smells like petrol. then slowly it turns on. What could it be? thanks and good job
@branchoffice1327 8 ай бұрын
See comment below
@andrehudson1000 10 ай бұрын
I have a 2001 base Boxster that I’m rebuilding. Did you have to swap wiring harness in the car ?
@branchoffice1327 10 ай бұрын
yes and no. I used the wiring harness from the 99 (its going into the 99) but had to install it on the 2001 engine. There are a couple of small differences. o2 connectors are different. I installed a 99 coolant temp sensor on the 01 engine. I eliminated the intake crossover valve in the rear crossover and I had to modify the front crossover (custom silicone boots) so that I could use the crossover from the 99(it is bigger). Most things have videos on the Channel. Feel free to ask anything. I would be glad to help.
@andrehudson1000 10 ай бұрын
In my case, I purchased a harness that was supposed to be out of a 01 with 2.7. After I put it in my 01 I realized it was out of a 99 with a 2.5. Now I’m trying to figure out how to make it work.