No video

power drive v1 to I-pilot, 8 wires to connect this is easy.

  Рет қаралды 3,992

Omie

Omie

Күн бұрын

paried remote and dry tested on land, time to replace seals on motor and I have a new setup for 600$.
contact jason at northland marine, great support.

Пікірлер: 13
@3dahlboyzsportz247
@3dahlboyzsportz247 2 жыл бұрын
I have a V1…..What would I need to make it a spot lock trolling motor. Thanks
@omieyouknowme
@omieyouknowme 2 жыл бұрын
New head unit and replace the main power board that's in the base about 650$ and hour of time
@jw5594
@jw5594 3 жыл бұрын
Hi, Do you have any videos of this troller working with the new ipilot config and controller? Thinking about doing this exact upgrade to a PD V1
@omieyouknowme
@omieyouknowme 3 жыл бұрын
I do not but will soon have a other where I measure the amp draw from the new control board. I have been using it for 7 months and can't believe how much I use spot lock. It's an expensive upgrade, and if you have co pilot with autopilot you really are only missing spot lock feature. There is cruise control and record tolling track and repeat but don't use them. If u can do without spot lock then stick with what you have.
@jw5594
@jw5594 3 жыл бұрын
@@omieyouknowme my autopilot and co pilot are both acting up
@omieyouknowme
@omieyouknowme 3 жыл бұрын
@@jw5594 the compass board often goes bad for co pilot/auto pilot, they are cheaper than pilot at 100-140$ and easy to replace about 5 min. I have done it twice in two power drive v1 I had. The head unit is the brains, the power board is in the base. The motors down in water don't car what runs it.
@kirkmartin2223
@kirkmartin2223 3 жыл бұрын
I have a Power drive V1 with co-pilot. What would I need to get it to run Ipilot? I don't have or care to have a foot pedal. Thanks in advance
@omieyouknowme
@omieyouknowme 3 жыл бұрын
The main board in the base and the Bluetooth head up top. The new control board will come with round plug.
@omieyouknowme
@omieyouknowme 3 жыл бұрын
Ping northland marine, James knows what u need.
@kirkmartin2223
@kirkmartin2223 3 жыл бұрын
Thank you sir
@johnschoechert2587
@johnschoechert2587 3 жыл бұрын
Is there a way to convert my V1 auto pilot to a V2 so I can use a round plug foot control? Minn Kota stopped offering replacement flat plug foot control pedals
@omieyouknowme
@omieyouknowme 3 жыл бұрын
Yes, you have to buy the main board from terrova model which is 250$ in addition to new foot pedal.
@johnschoechert2587
@johnschoechert2587 3 жыл бұрын
@@omieyouknowme thanks. May have upgrade a new trolling motor.
Foot pedal COMPLETE
13:14
Jeffrey Goldberg
Рет қаралды 9 М.
Can This Bubble Save My Life? 😱
00:55
Topper Guild
Рет қаралды 86 МЛН
王子原来是假正经#艾莎
00:39
在逃的公主
Рет қаралды 16 МЛН
Running With Bigger And Bigger Feastables
00:17
MrBeast
Рет қаралды 166 МЛН
OMG what happened??😳 filaretiki family✨ #social
01:00
Filaretiki
Рет қаралды 13 МЛН
Minn Kota Power Drive V1 & V2 foot pedal fix!
5:31
Kevin Mastroianni
Рет қаралды 1,2 М.
How to Install a Minn Kota i-Pilot System on a PowerDrive V2
5:51
Minn Kota Tutorials
Рет қаралды 41 М.
Minn Kota trolling Motor Clicking Problem Solved!!
5:11
Renegade RC-FPV
Рет қаралды 20 М.
Minn Kota Powerdrive V2 transducer installation
4:24
CAB SOL
Рет қаралды 84 М.
Docking A SINGLE Engine Boat SIDEWAYS!
8:05
Born Again Boating
Рет қаралды 3,5 МЛН
COMMUNISM vs CAPITALISM: Who Made Better Power Tools?
24:39
The Doubtful Technician
Рет қаралды 664 М.
minn kota V1 foot pedal fix
12:09
AJ Wildhorse
Рет қаралды 1,8 М.
Can This Bubble Save My Life? 😱
00:55
Topper Guild
Рет қаралды 86 МЛН