After buying a Predator 4000 generator from online marketplace, I started digging in and trying to find out what all was wrong..starting with the incomplete carburetor. #smallengine #engine #harborfreight
Пікірлер: 28
@mrwill09106 ай бұрын
I got the same issue and the same product. I am as well trying to get it to run after crank failure. Very good content
@wendellcautrell19366 ай бұрын
Try turning the Fuel on.
@MyEngineerChannel4 жыл бұрын
I bought the older version of this generator last week. Nothing was coming through the valve initially... after blowing compressed air through it I got flow and it fired but didn’t run. I bought what looks like the same kit and a replacement valve from Amazon. It looks like your gasket placement was off; I did swap out the black piece as well and used the new plug. The generator fired on the first pull and ran fine in my case.
@justinmadison97542 жыл бұрын
I'm sorry 4
@Mikesorrento33445 жыл бұрын
Run AVGAS 91 octane. There’s no ethanol and this gas is stable for a couple of years. Yes, it’s $4.50 a gallon, but you will save yourself many headaches.
@Mikesorrento33444 жыл бұрын
Lead serves as a cylinder lubricant. Running leaded fuel in a generator, lawnmower (Small engines) etc is fine. Running leaded fuel in a modern car is where you have to be concerned. It will foul catalytic converters, sensors. It’s you don’t want to run unleaded fuel in an engine designed for leaded fuel. Thanks
@glenngrimstad19504 жыл бұрын
Ya probably figured it out but as Bob N said. The gasket you put between that plate and the card with the small bumps it in it goes between the filter box and the carb. She will start in a second after that..
@Awfullyjake Жыл бұрын
dam!!!! that was my problem thank you!!!!
@the_izB5 ай бұрын
So, your carb video is cool, helped alot. My generator keeps shutting down though. I hear like a clink, like something sounds like its flying around right before it dies.Any idea what hell I am about to face?
@joeyserrano21308 ай бұрын
@bobconwill1890 Жыл бұрын
Looks like you have the fuel valve in the off position?
@wendellcautrell19367 ай бұрын
that's exactly what I'm thinking
@Bart12349 Жыл бұрын
I start mine up and it keeps cutting out. I think I need to clean the gunk out of the fuel shut-off just like you had done.
@ASliceofWoodWorkshop Жыл бұрын
Most likely a dirty carb needle. It may not be letting enough fuel into the float bowl.
@copedennis14 жыл бұрын
Need to hook the throttle springs back on
@Captainkleen5 жыл бұрын
Is your throttle body spring hooked up? Since it wanted to run turn throttle body off choke to run if it runs check your throttle body linkage and your governor you may of forgotten to hook those wires up.
@alext88283 жыл бұрын
This is the second video I've watched of yours and you keep shutting off the fuel valve. The valve part is in the tube that runs up to the tank. The fuel flows when the valve handle is aligned with that tube. Not the tube and fuel line with the filter in it.
@Jim-ie6uf5 жыл бұрын
Did you hook the throttle lever and dampener spring back up? Can’t beat about $12.50 for the carb on Amazon.
@ASliceofWoodWorkshop5 жыл бұрын
Yeah. Going to look more into it today. Make sure that I have good fuel flow going into the carb.
@Jim-ie6uf5 жыл бұрын
Update the video when you finish, there’s tons of these things out there.
@mgoody87823 жыл бұрын
If it was previously messed with the price gos down
@Hugo-Hernandez4 жыл бұрын
Did you ever figure out the issue ?
@ASliceofWoodWorkshop4 жыл бұрын
Engine ran well. The generator part was bad. A person had similar generator with a bad motor and bought this.
@bobn88654 жыл бұрын
got the wrong gasket between the engine and carb. switch the two gaskets around.
@glenngrimstad19504 жыл бұрын
Yup,, Beat me to it..
@victorherrera52552 жыл бұрын
Do you have the parte number of the Fuel Valve?
@ASliceofWoodWorkshop2 жыл бұрын
I do not any longer have that information. If you can find your engine number and do a search, information like that will usually come up.