Рет қаралды 480,480
Holts two-component clear paint spray for professional headlights
Headlight Refinisher
Professional spray paint, but very easy to use and impressive finish
Two coats of the paint gave a mirror-like surface, and no polishing correction was necessary after drying.
The plastic becomes the texture of glass lenses!
The instructions say to start polishing at #400.
However, in order to remove fine cracks on the lens, I started polishing from No. 120.
(From 120 to 320 to 400 to 600 to 800 to 1000 to 1200 to 1500 to 2000)
After surface preparation, degrease the lens, but we recommend using a neutral detergent.
*Silicon off and parts cleaners may damage polycarbonate.
*Polish the lens surface to obtain a PC ground surface with no coating layer.
Tightening the cap at the bottom of the can upside down will start mixing the two liquids
Expiration date is within 8 hours after mixing
The paint mist was a fine spray paint with good adhesion.
Unevenness and dripping are unlikely to occur.
The first coat left a yuzu surface, and the second coat eliminated unevenness on the painted surface, leaving a glossy mirror-like surface.
The second time, the painted surface became smooth and mirror-like.
After painting
The painted surface dries in 15 to 20 minutes (finger dry)
Complete drying in about 24 hours
One spray can be enough for one 10 series Alphard (left and right headlights).
It has the capacity to paint, and if it is a small headlight, it is enough for 4 headlights